Hot Tub Rules: Clovis vs Reedley
How do hot tub rules rules compare between Clovis, CA and Reedley, CA?
Clovis and Reedley have similar restriction levels.
Clovis, CA
Fresno County
Hot tubs/spas with a lockable safety cover (ASTM F1346) are exempt from the CA pool barrier requirement per CA H&S §115921(b). Clovis building/electrical permits still required for installation.
View full Clovis rules →Reedley, CA
Fresno County
Hot tubs and spas in Reedley are regulated under the 2022 California Building Code and the California Swimming Pool Safety Act (Health and Safety Code Sections 115920-115929). Spas with water depths of 18 inches or more are subject to the same barrier requirements as swimming pools, unless they are equipped with a locking safety cover meeting ASTM F1346 standards that can support at least 485 pounds. A compliant safety cover counts as one of the two required safety features under HSC Section 115922. Electrical installations for hot tubs require permits from the Building Division and must include GFCI protection and a disconnect switch within sight of the spa and at least 5 feet from the water's edge. All hot tubs must comply with anti-entrapment drain requirements under the Virginia Graeme Baker Act. Portable hot tubs using plug-in 120V connections may not require an electrical permit, but hardwired 240V installations always do. Spas must be maintained in sanitary condition to prevent health hazards.
View full Reedley rules →Key Facts Comparison
| Fact | Clovis | Reedley |
|---|---|---|
| Cover Exemption | ASTM F1346 | - |
| State Law | CA H&S §115921(b) | - |
| Electrical Permit | Required | Required for hardwired spas |
| NEC | §680.42 | - |
| Safety Cover Standard | - | ASTM F1346 (485 lbs capacity) |
| GFCI Protection | - | Required |
| Disconnect Switch | - | Within sight, 5+ feet from water |
| Building Division | - | (559) 637-4200 |
Highlighted rows indicate differences between cities.
Clovis FAQ
Do I need a pool fence around my hot tub in Clovis?
Not if your spa has an ASTM F1346 locked safety cover. CA H&S §115921(b) exempts covered spas from the 60" barrier rule.
Do I need an electrical permit for a hot tub in Clovis?
Yes. The 240V circuit must be GFCI-protected and bonded per NEC §680.42, which requires a Clovis electrical permit and final inspection.
Can my hot tub pump violate Clovis noise rules?
Yes. Spa pump noise must stay under the CMC Ch. 5.24 limits — 55 dBA at night and 65 dBA during the day at the property line. Neighbors can file a noise complaint on chronic hum.
Reedley FAQ
Do I need a permit for a hot tub in Reedley?
Hot tubs with hardwired 240V electrical connections require an electrical permit. Portable plug-in hot tubs on standard 120V circuits may not require a permit in all cases. Contact the Building Division at (559) 637-4200 to confirm requirements for your specific installation.
Can a safety cover replace a fence for my hot tub?
Yes. A locking safety cover meeting ASTM F1346 standards that can support at least 485 pounds can serve as one of the two required safety features under the Swimming Pool Safety Act, potentially eliminating the need for a separate 60-inch fence around the spa.
What are the electrical requirements for a hot tub in Reedley?
Hot tubs require GFCI-protected circuits and a manual disconnect switch visible from the spa and at least 5 feet from the water's edge. All hardwired electrical work must comply with the National Electrical Code and be inspected by the Building Division.
Compare other topics
See how Clovis and Reedley compare on other ordinance categories.
Want to add a third city?
Use our full comparison tool to compare up to three cities.
Open Comparison Tool