Fencing Requirements: Jurupa Valley vs Menifee
How do fencing requirements rules compare between Jurupa Valley, CA and Menifee, CA?
Jurupa Valley and Menifee have similar restriction levels.
Jurupa Valley, CA
Riverside County
Jurupa Valley enforces California's statewide pool-barrier standard from Health & Safety Code §115923. A perimeter enclosure (fence/wall) is one of seven approved drowning-prevention features under H&S §115922, but if you use a fence, it must be at least 60 inches tall, have less than 2 inches of clearance below, have no climbable handholds on the outside, and have a self-closing gate with a self-latching device placed at least 60 inches above the ground that opens away from the pool.
View full Jurupa Valley rules →Menifee, CA
Riverside County
Under California Health & Safety Code §115923 (adopted statewide and enforced through MMC Title 15's adoption of the California Building Code), any pool barrier installed to satisfy the Swimming Pool Safety Act must be at least 60 inches (5 feet) high, with no more than 2 inches of vertical clearance between the ground and the bottom of the enclosure. The barrier must isolate the pool from the home and from the rest of the yard. Menifee does not relax this standard.
View full Menifee rules →Key Facts Comparison
| Fact | Jurupa Valley | Menifee |
|---|---|---|
| Minimum fence height | 60 in. (H&S §115923(a)) | - |
| Bottom clearance | ≤ 2 in. (H&S §115923(b)) | - |
| Picket gap | Must reject a 4-in. sphere (H&S §115923(c)) | - |
| Gate latch | Self-closing/self-latching at ≥60 in., opens away from pool (H&S §115923(e)) | - |
| Climbability | No exterior handholds/footholds for under-5 child (H&S §115923(d)) | - |
| Minimum height | - | 60 inches (5 ft) per Cal. H&SC §115923 |
| Maximum ground clearance | - | 2 inches under the bottom of the barrier |
| Gates | - | Self-closing, self-latching; release mechanism at least 60 in. above ground |
| Removable mesh alternative | - | Must meet ASTM F2286 |
| Local adoption | - | MMC Title 15 adopts CBC/CRC which incorporates these standards |
Highlighted rows indicate differences between cities.
Jurupa Valley FAQ
Can I use my existing 6-ft backyard fence as the pool barrier?
Yes, if the entire pool-side enclosure meets H&S §115923 — 60+ in. tall, ≤2 in. clearance, no climbable face, and the gate is self-closing/self-latching at 60+ in. Older chain link or fences with horizontal rails on the outside often fail the climbability test.
Does the fence have to surround just the pool, or can it use the house wall?
Either is allowed. If the house wall is part of the enclosure, doors with direct pool access need a self-closing/self-latching device 54+ in. above the floor (H&S §115922(e)) or an audible exit alarm (§115922(d)), which counts as one of the two required safety features.
Is a pool cover enough by itself?
An ASTM F1346-23 safety cover satisfies one of the two required SB 442 features, but you still need a second feature — typically the perimeter fence or door/window alarms. Solar/floating covers do not qualify.
Menifee FAQ
Can my existing 4-foot yard fence count as the pool barrier?
No. The Swimming Pool Safety Act requires a minimum 60-inch (5-foot) barrier between the home and the pool, with restricted ground clearance and self-closing gates. A typical 4-foot perimeter fence does not satisfy §115923.
Does the fence have to surround just the pool or the whole yard?
Cal. H&SC §115922 calls for an 'isolation' enclosure that separates the pool from the residence and from the rest of the yard, not merely a perimeter fence — unless you pair other listed safety features instead.
Compare other topics
See how Jurupa Valley and Menifee compare on other ordinance categories.
Want to add a third city?
Use our full comparison tool to compare up to three cities.
Open Comparison Tool