Fence Requirements: Reedley vs Selma
How do fence requirements rules compare between Reedley, CA and Selma, CA?
Reedley and Selma have similar restriction levels.
Reedley, CA
Fresno County
RMC 10.34.050 mandates solid masonry walls where properties abut arterials and freeways. The Community Development Director sets wall specs based on noise and hazard factors.
View full Reedley rules →Selma, CA
Fresno County
Selma's comprehensive fence requirements under SMC 11-20-14 establish a detailed regulatory framework covering height limits by yard location, material restrictions by zoning district, special provisions for commercial-residential buffer interfaces, and standards for screening outdoor storage. The ordinance requires a six-foot solid masonry wall at the boundary between any area zoned C (Commercial), M (Manufacturing), or R-O (Residential-Office) and any adjacent residential area, serving as a noise and visual buffer that must be installed by the developer at the time of construction. In residential zones, standard fences may be up to six feet in side and rear yards, while front yards are limited to 48 inches for open fences and 42 inches for solid walls to maintain neighborhood visibility and streetscape character. Gates are included in the definition of fences, walls, and hedges and are subject to the same height restrictions as the fence they serve. Corner lot properties must comply with sight triangle visibility requirements at intersections, limiting fence height to 42 inches or less within the designated sight area. The 2024 Zoning Code Update consolidated and modernized fence standards, incorporating new provisions for screening requirements, RV storage enclosures, and updated development standards that work in conjunction with the existing SMC 11-20-14 framework.
View full Selma rules →Key Facts Comparison
| Fact | Reedley | Selma |
|---|---|---|
| Code | RMC Chapter 10.34 | - |
| Required Walls | Masonry along arterials and freeways | - |
| Sight Triangle | 3 ft max hedges at corners | - |
| CDD Authority | Determines wall specs per use | - |
| Code Section | - | SMC 11-20-14 |
| Residential Max | - | 6 ft side/rear, 42-48 in front |
| Commercial Buffer | - | 6 ft masonry wall required |
| Corner Lots | - | 42 in sight triangle |
| Advertising | - | Not permitted on fences |
Highlighted rows indicate differences between cities.
Reedley FAQ
Does Reedley require fences for any specific situations?
Yes. RMC 10.34.050 requires solid masonry walls where properties abut collector streets, arterials, expressways, and freeways to buffer noise. The Community Development Director sets wall height and specs based on the specific noise, danger, or hazard conditions.
Are there rules about corner lot fences in Reedley?
Yes. At intersections without traffic signals or stop signs, hedges, shrubs, and plants cannot exceed 3 feet in height to maintain driver visibility. Solid fences and walls in these sight-triangle areas may also be restricted.
Selma FAQ
What are the basic fence rules in Selma?
Fences up to 6 feet are allowed in side and rear yards. Front yards are limited to 48 inches for open fences or 42 inches for solid walls. Gates count toward height limits. A 10-foot driveway setback applies for fences over 42 inches near side-yard driveways. All fences must be maintained in good repair and may not display advertising.
Is a masonry wall required between my home and a commercial property in Selma?
Yes, if the commercial or industrial property was developed after the ordinance took effect. SMC 11-20-14 requires the developer of any C, M, or R-O zoned property to install a 6-foot solid masonry wall along the boundary with adjacent residential areas at the time of construction, at the developer's expense.
Compare other topics
See how Reedley and Selma compare on other ordinance categories.
Want to add a third city?
Use our full comparison tool to compare up to three cities.
Open Comparison Tool