Revere, MA Swimming Pools & Spas: Hot Tub Rules (2026)

Hot tubs and spas in Suffolk County are regulated like swimming pools when water depth exceeds 24 inches. Under 780 CMR Appendix G, 105 CMR 435, and 527 CMR 12.00 (MA Electrical Code adopting NEC Article 680), a permit is required for installation. Electrical permit from the local Wiring Inspector is always required for hardwired 240V hot tubs: dedicated 50-60 amp GFCI-protected circuit, disconnect within sight of the spa (minimum 5 feet away, maximum line-of-sight), equipotential bonding of all metal components, and no outlet within 6 feet of the tub edge. Plug-in 120V hot tubs still require GFCI protection but have less complex permitting. Barrier alternatives: a safety cover meeting ASTM F1346 locked when not in use satisfies the barrier requirement in all four Suffolk County municipalities — this is the most common compliance method. Without a compliant cover, the hot tub requires a 6-foot fence per 105 CMR 435 or 48-inch barrier per 780 CMR Appendix G. Setback requirements: typically 5 feet from side/rear property lines under local zoning; check specific city code. Structural considerations: hot tubs weigh 3,000-5,000 pounds when filled — deck-mounted installations require structural engineering to ensure adequate load capacity (40 psf minimum live load, often 60+ psf for spa area). Drainage: discharge to storm drains prohibited under MS4 permits; discharge to sanitary sewer may require dechlorination and utility approval. Indoor spas require mechanical ventilation per 780 CMR and dehumidification to prevent building damage.