Skip to main content
CityRuleLookup

Atlantic County, NJ Environmental Rules: Flood Zones (2026)

Significant Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified August 2026

FEMA flood zone rules in Atlantic County, NJ, also called floodplain regulations or special flood hazard area (SFHA) rules, determine flood insurance requirements and elevation standards for new construction.

Key Facts

Covered zones
FEMA A Zone and V Zone flood hazard areas
Encroachment rule
barred absent no-rise engineer/architect certification
Drainage requirement
adequate drainage mandatory for all development
Plan disclosure
flood zone, BFE and FIRM panel number required
Final plat note
elevation certificate and flood insurance advisory

Summary

Atlantic County bars new encroachments in a FEMA A or V Zone flood hazard area it reviews unless a professional engineer or architect certifies the project will not raise the base flood elevation, and requires every such development to minimize flood damage and provide adequate drainage.

These county ordinances apply to unincorporated areas of Atlantic County. Incorporated cities within the county may have their own rules that take precedence over county-level regulations.

The policies and design principles identified in this section apply to any land development and improvements, subject to County review, that are located within a flood hazard area as defined in N.J.A.C. 7:7-9.25. Flood hazard areas include, but are not limited to, those areas defined or delineated as an A or a V Zone by the Federal Emergency Management Agency (FEMA). ... Avoid new development in a flood hazard area. Encroachments within a flood hazard area shall be prohibited unless a certification by a professional engineer or architect is provided demonstrating that an encroachment shall not result in any increase in the base flood elevation. ... All development shall be consistent with the need to minimize flood damage while maintaining the natural and beneficial functions of a flood hazard area. All development shall provide adequate drainage to reduce exposure to flood hazards.

View official code

Official source re-checked September 7, 2026: no newer edition of the code had been published (publisher’s edition: rev 4863463; v25 updated 2026-04-21; through 04-21-2026).

Full Breakdown

C. 25, which the County code identifies as including, but not limited to, an A Zone or V Zone as delineated by FEMA. Section 86-801(C) lays out three general policies. First, and most restrictive, new development in a flood hazard area is to be avoided, and encroachments are flatly prohibited unless a professional engineer or architect certifies that the encroachment will not increase the base flood elevation, putting the burden of proof on the applicant before the County will consider the encroachment. Second, all development must be consistent with minimizing flood damage while maintaining the natural and beneficial functions of the flood hazard area, meaning the County can weigh ecological function, not just structural safety, in reviewing a plan.

Third, every development must provide adequate drainage to reduce flood hazard exposure. Section 86-801(B) points applicants to County-maintained maps identifying flood hazard areas, County roadway depth below base flood elevation, and current, 2050 and 2100 coastal flooding exposure, all available on the County website, so an applicant can check exposure before design. Section 86-802 then layers enhanced submission requirements onto any land development application in a flood hazard area: the plan must note the flood zone, base flood elevation and FIRM panel number, identify lowest floor elevations on the FIRM datum, locate and describe protection for utilities and heating and electrical equipment, disclose any basement or below-grade enclosure with foundation-opening drawings, describe construction materials used below base flood elevation, and carry advisory notes on the final plat that the site may face additional floodplain management rules and will need an elevation certificate and flood insurance.

Violations & Fines

Section 86-801 has no standalone fine; it operates as a bar to DRC approval. An application proposing an encroachment in a flood hazard area without the required professional engineer or architect no-rise certification does not get County site plan or subdivision approval, and § 86-802's missing submission items (FIRM panel number, lowest floor elevation, utility protection description) will likewise stall review until supplied.

Frequently Asked Questions

Can I build in an Atlantic County flood hazard area?
Only with restrictions. Section 86-801(C) directs the County to avoid new development in a flood hazard area and prohibits encroachments unless a professional engineer or architect certifies the project will not increase the base flood elevation.
What flood zones does Atlantic County's flood hazard policy cover?
Section 86-801(A) applies the policy to any flood hazard area as defined in N.J.A.C. 7:7-9.25, which it states includes, but is not limited to, areas FEMA delineates as an A Zone or a V Zone.
What extra information does a flood-zone site plan need in Atlantic County?
Section 86-802 requires the plan to note the flood zone, base flood elevation and FIRM panel number, identify lowest floor elevations, locate and describe protection for utilities, and carry a final-plat advisory note about needing an elevation certificate and flood insurance.

Sources & Official References

Other rules in Atlantic County

All Atlantic County rules

Compare Atlantic County to another location·View the New Jersey environmental rules overview

Get notified when Flood Zones in Atlantic County, NJ changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.

Flood Zones in Cities Across Atlantic County