Skip to main content
CityRuleLookup

Washington County, OR Zoning Overlays & Bonuses: Density Bonus Law (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified September 2026

Key Facts

Base density
5-6 units/acre in R-6 North Bethany District
Bonus amount
Up to 3 additional units per acre
Maximum with bonus
9 units per acre
Required review
Type III Planned Development, Section 390-17.7
Geographic scope
R-6 North Bethany District only, unincorporated

Summary

In unincorporated Washington County's R-6 North Bethany District, a project may add up to three units per acre above the base five-to-six-unit density, reaching nine units per acre, but only through a Type III Planned Development on a site the North Bethany Subarea Plan designates as bonus-eligible.

City-specific rules exist: Hillsboro, and Beaverton have their own density bonus law rules that differ from Washington County's county-level regulations. If you live in one of those cities, check the city-specific page instead.

B.Other housing (residential development that does not meet the definition of Middle Housing in Section 106):(1)The permitted residential density shall be no more than six units per acre and no less than five units per acre, except as otherwise specified by Section 300-2 or by Section 390-8.5 B(2) below.(2)A density bonus is permitted when the following standards are met:(a)The development shall be a Type III Planned Development subject to Section 390-17.7;(b)The density bonus does not exceed three units per acre, resulting in a maximum density of nine units per acre; and(c)The development site is designated by the North Bethany Subarea Area Plan as being eligible for a density bonus.

View official code

Official source re-checked September 7, 2026: no newer edition of the code had been published (publisher’s edition: Community Development Code: Supplement 2 | Code of Ordinances: Supplement 25).

Full Breakdown

Washington County's Community Development Code allows a density bonus in exactly one residential zoning district: the R-6 North Bethany District (R-6 NB), created for the North Bethany Subarea Plan in unincorporated Washington County. B sets the district's base density for "other housing" (any residential development that does not meet the Code's Middle Housing definition) at no more than six units per acre and no less than five units per acre. 7, the county's most demanding, public-hearing-based approval track; the bonus itself cannot exceed three units per acre; and the North Bethany Subarea Plan must specifically designate the development site as eligible for a bonus.

Land Use & Transportation's Long Range Planning Division administers the North Bethany Subarea Plan and reviews Planned Development applications for R-6 NB projects. 5, or to any other unincorporated county zoning district; those areas follow the density rules of their own base zone sections. The bonus has no application inside Hillsboro, Beaverton, or the county's other incorporated cities, which administer their own zoning codes independent of the county's Community Development Code.

Violations & Fines

A project that fails any one of the three density-bonus standards, wrong review track, excess bonus amount, or an ineligible site, is capped at the base five-to-six-unit range. Washington County's Long Range Planning Division can deny or condition Planned Development approval under Section 390-17.7, and building or platting above the approved density without a valid bonus approval is a Community Development Code violation subject to the county's land use enforcement process.

Frequently Asked Questions

Does this density bonus apply countywide?
No. It applies only within the R-6 North Bethany District, one district created by the North Bethany Subarea Plan in unincorporated Washington County. Sites in Hillsboro, Beaverton, or any other county zoning district are governed by separate density rules, and this bonus does not reach them under Section 390-8.5.B(2).
How much extra density can a project earn?
Up to three additional units per acre above the district's base range of five to six units per acre, for a maximum of nine units per acre. Section 390-8.5.B(2)(b) caps the bonus at that level regardless of site size or other project features.
What approval process does a density-bonus project need?
The development must be processed as a Type III Planned Development under Section 390-17.7, Washington County's hearings-based discretionary review track. A standard Type I or Type II land use application cannot secure the density bonus; only a Planned Development approval can, per Section 390-8.5.B(2)(a).
Is every North Bethany site eligible for the bonus?
No. Only sites the North Bethany Subarea Plan specifically designates as eligible for a density bonus qualify. Section 390-8.5.B(2)(c) makes that designation a required condition, so the Community Development Code does not allow the bonus on land the subarea plan leaves out.

Sources & Official References

Other rules in Washington County

All Washington County rules

Compare Washington County to another location·View the Oregon zoning overlays & bonuses overview

Get notified when Density Bonus Law in Washington County, OR changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.

Density Bonus Law in Cities Across Washington County