Skip to main content
CityRuleLookup

Shasta County, CA Building Safety: Electrical Permits (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified August 2026

Key Facts

Governing law
Shasta County Code § 16.10.340
Program
Limited Density Owner-Built Rural Dwellings
Eligible areas
Carr, Zogg, Salt, Fawn wildfire zones
Adopted code
California Electrical Code, Title 24 Part 3
Wiring mandate
none unless power is installed
Enforcement
nuisance abatement under Section 16.10.060

Summary

Shasta County's owner-built rural dwelling program does not force any dwelling to hook up to electrical power, but Code Section 16.10.340 requires that whatever wiring or electrical appliance is installed meet the current California Electrical Code, Part 3, Title 24. The rule applies only to Limited Density Owner-Built Rural Dwellings permitted under Chapter 16.10 in the Carr, Zogg, Salt, and Fawn wildfire-impact areas.

City-specific rules exist: Redding has its own electrical permits rules that differ from Shasta County's county-level regulations. If you live in Redding, check the city-specific page instead.

Where electrical wiring or appliances are installed, the installation shall be in accordance with the applicable requirements contained in the most recently adopted version of the California Electrical Code, Part 3, Title 24, California Code of Regulations.

View official code

Official source re-checked September 7, 2026: no newer edition of the code had been published (publisher’s edition: Code: Supplement 22).

Full Breakdown

10, adopted by Ordinance No. 2 and Title 25 of the California Code of Regulations, creates a separate, cheaper permitting track for owner-built homes lost in the Carr wildfire (2018), Zogg wildfire (2020), Salt wildfire (2021), and Fawn wildfire (2021). 330 confirms no dwelling or appurtenant structure built under this chapter must be wired for electrification. 340 kicks in only once wiring or an appliance is added: the installation must then follow the most recently adopted California Electrical Code, Part 3, Title 24, California Code of Regulations.

350 narrows the scope further, allowing a builder to wire only the room or rooms that actually use electricity, such as a kitchen or workshop, and to leave the rest of the structure unwired, unless the building official determines the electrical demand will exceed that room's capacity and orders further electrification. ' Structures outside this specific rebuild program follow the county's ordinary Title 16 building permit and code-adoption process instead.

Violations & Fines

A structure wired in violation of Section 16.10.340's electrical standard can be found substandard and declared a public nuisance under Section 16.10.060, abatable through Chapter 8.28 (Nuisances) of the county code. The building official is directed to pursue civil abatement first when an owner ignores a correction order, though that remedy is cumulative to every other enforcement tool the county has.

Frequently Asked Questions

Do owner-built rural dwellings in Shasta County have to be wired for electricity?
No. Section 16.10.330 says no dwelling or appurtenant structure built under Chapter 16.10 has to be connected to electrical power or wired for it. If wiring is added anyway, Section 16.10.340 requires the installation to meet the current California Electrical Code, Part 3, Title 24.
Which homes qualify for Shasta County's electrical exemption?
Only Limited Density Owner-Built Rural Dwellings permitted under Chapter 16.10, built by the owner in rural parcels within the mapped Carr, Zogg, Salt, or Fawn wildfire impact areas. Ordinary residential construction elsewhere in the county still follows the standard Title 16 building and electrical permitting process.
Can a builder wire just one room instead of the whole house?
Yes. Section 16.10.350 lets a builder confine wiring to rooms that actually need power, like a kitchen or workshop, and leave the rest unwired, unless the building official decides the electrical demand will outgrow that room and orders more of the structure wired.
What happens if the electrical work does not meet the adopted code?
The building official can classify the installation as a substandard building under Section 16.10.060, which the county treats as a public nuisance subject to abatement through Chapter 8.28, in addition to any other remedy available under the Shasta County Code.

Sources & Official References

Other rules in Shasta County

All Shasta County rules

California rules heatmap·Compare Shasta County to another location·View the California building safety overview

Get notified when Electrical Permits in Shasta County, CA changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.

Electrical Permits in Cities Across Shasta County