Skip to main content
CityRuleLookup

Olmsted County, MN Building Setbacks & Zoning: Lot Coverage Limits (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified September 2026

Key Facts

R-2 max lot coverage
40% of lot
R-2 development site coverage cap
40%
R-1 lot coverage cap
none set
R-1 density control
2-acre min lot size
Enforcement
Ch. 1400 § 3.10, misdemeanor

Summary

Structures on an R-2 Mixed Low Density Residential lot in unincorporated Olmsted County can't cover more than 40 percent of the lot, the only numeric lot-coverage cap the base zoning ordinance sets, under Section 6.04(C)(9); the county's other general residential district, R-1, has no equivalent percentage cap.

These county ordinances apply to unincorporated areas of Olmsted County. Incorporated cities within the county may have their own rules that take precedence over county-level regulations.

9. Lot Coverage Regulations: a) The maximum lot coverage of all structures does not exceed forty (40%) percent of the lot.

Full Breakdown

04(C)(3)(d)(3), which requires that "the maximum lot coverage of all structures does not exceed forty (40%) percent of the entire development site" before a project can skip the district's standard minimum lot area requirements. 02; its density is instead controlled through minimum lot size, generally two acres per dwelling, and the 100-foot minimum lot width at the front building line, so the 40 percent figure is specific to R-2 and to development sites within it, not a county-wide cap. Lot coverage in this context counts building footprint, not overall site impervious surface such as driveways or patios, which fall under the county's stormwater and floodplain provisions rather than the base zoning district regulations.

A property owner planning an addition or accessory building in R-2 should measure existing footprint against the 40 percent ceiling before applying for a building permit, since exceeding it after the fact triggers enforcement rather than approval.

Violations & Fines

Constructing or expanding a building beyond the 40 percent lot-coverage cap in the R-2 district is a zoning violation. Ch. 1400 § 3.10 makes any zoning violation a misdemeanor, and the county can require removal or reduction of the offending structure in addition to prosecuting each day of the violation as a separate offense.

Frequently Asked Questions

What percentage of my lot can I build on in Olmsted County?
In the R-2 Mixed Low Density Residential District, Section 6.04(C)(9) caps total building footprint at 40 percent of the lot. That's the only district in the base zoning ordinance with an explicit lot-coverage percentage.
Does the R-1 district have the same 40% cap?
No. R-1 Low Density Residential doesn't set a lot-coverage percentage at all; instead it limits density through a roughly two-acre minimum lot size per dwelling and a 100-foot minimum lot width, under Section 6.02(C).
Does the 40% limit include my driveway and patio?
No, "lot coverage of all structures" in Section 6.04(C)(9) refers to building footprint, not general impervious surface. Driveways, patios and other paved areas are addressed separately under the county's stormwater and floodplain rules, not this base zoning cap.

Sources & Official References

Other rules in Olmsted County

All Olmsted County rules

Compare Olmsted County to another location·View the Minnesota building setbacks & zoning overview

Get notified when Lot Coverage Limits in Olmsted County, MN changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.

Lot Coverage Limits in Cities Across Olmsted County