Okaloosa County, FL Building Setbacks & Zoning: Structure Height Limits (2026)
Key Facts
- R-1 height cap
- 45 feet
- Governing table
- LDC § 2.03.06, Table 2.3
- Front setback
- 20 feet minimum
- Side/rear setback
- 10 feet minimum
- Admin height increase
- Only in I-1 and C-3 zones
Summary
In Okaloosa County's R-1 single-family residential district, Table 2.3 caps building height at 45 feet. The same table sets minimum 20-foot front and 10-foot side and rear setbacks and a 20-foot minimum lot frontage for the unincorporated county's most common residential zone.
Bulk regulations for R-1 districts shall be as prescribed in Table 2.3.
TABLE 2.3 RESIDENTIAL — 1 BULK REGULATIONS MAXIMUM DENSITY North of Eglin AFB no more than 4 dwellings/acre South of Eglin AFB no more than 5 dwellings/acre MAXIMUM INTENSITY 0.10 FAR (non-residential uses) 55% ISC MINIMUM BUILDING SETBACKS Front 20 feet 1 Sides 10 feet Rear 10 feet MINIMUM LOT FRONTAGE 20 feet MAXIMUM BUILDING HEIGHT 45 feet
Official source re-checked September 7, 2026: no newer edition of the code had been published (publisher’s edition: Code of Ordinances: Supplement 23).
Full Breakdown
Section 2.03.06 of the Land Development Code adopts Table 2.3, the bulk regulations schedule for the Residential-1 (R-1) district, the standard single-family zoning classification across unincorporated Okaloosa County outside the cities. The table's maximum building height line sets the cap at 45 feet, applied identically whether the lot sits north or south of Eglin Air Force Base. That 45-foot figure recurs across most of the county's other base residential and commercial districts, including R-2, Suburban Residential, and the C-1 and C-2 commercial districts, but higher-intensity districts such as C-3, Industrial-1 and the Mixed Use district allow taller buildings, up to 100 feet in I-1.
An applicant who wants to build above the district cap has two paths in the Code. Section 2.19.00 footnote 6 allows a compatibility analysis for requests to exceed a 75-foot maximum height where that ceiling applies, weighing land use, building orientation, traffic, and shadow impacts on neighboring parcels. Separately, Section 1A.04.05(6) lets the planning official approve an administrative height increase of up to 30 percent above the maximum otherwise allowed, but only in the Industrial-1 and General Commercial (C-3) districts, and only with sign-off from the county's aviation advisory committee, a reflection of how much of the county sits under military flight paths tied to Eglin and Hurlburt Field.
R-1's 45-foot cap has no such carve-out; it is a flat maximum enforced at the building permit stage before construction begins.
Violations & Fines
Building above the district's height cap without an approved variance or compatibility analysis is a Land Development Code violation, enforced first at building permit review by Growth Management and, if construction proceeds anyway, referred to the Code Enforcement Board. The board can fine a first violation up to $250 per day and a repeat violation up to $500 per day under Okaloosa County Code of Ordinances §§ 11-606 and 11-607, and may order a noncompliant structure brought into compliance.
Frequently Asked Questions
How tall can I build a house in an R-1 zone in unincorporated Okaloosa County?
Can I get an exception to build taller than 45 feet in R-1?
Does the 45-foot cap apply the same way near Eglin Air Force Base?
Sources & Official References
Other rules in Okaloosa County
Florida rules heatmap·Compare Okaloosa County to another location·View the Florida building setbacks & zoning overview
See something wrong?
Help us keep this page accurate. If you notice an error or outdated information, let us know.