Knox County, TN Fire Regulations: Smoke Detectors (2026)
Key Facts
- Adopted code
- 2018 NFPA Life Safety Code, Sec. 30-56
- Detector locations
- Every bedroom, sleeping-area corridor, each apartment level
- Standard
- Installed per LSC 9.6 and NFPA 72
- Applies to
- Multi-occupancy buildings with a residential sleeping use
- Plan review
- Knox County Codes Administration and Inspections
- Amendment source
- Ord. No. O-18-10-101, § 14, 11-19-18
Summary
Knox County's 2018 Life Safety Code amendments require a fire alarm detection system with smoke or heat detectors in any multiple-occupancy building where at least one occupancy is residential and people sleep. Sec. 30-57 places detectors in every bedroom, in corridors serving sleeping areas, and on every apartment level, reviewed by Codes Administration before installation.
Add a new section as follows: "Section 6.1.14.1.4 All multiple occupancies of which at least one of the occupancies is of residential use, in which occupants sleep shall be equipped with a fire alarm detection system installed in accordance with LSC 9.6 and NFPA 72. Smoke or heat detection (depending on the areas to be protected and the use of the area) shall be installed in the following locations: Residential area used for sleeping purposes: 1.Within all bedrooms or sleeping rooms.2.Centrally located in a corridor or area giving access to each group of rooms used for sleeping purposes, and3.On every level of the residential apartment."
Official source re-checked September 7, 2026: no newer edition of the code had been published (publisher’s edition: Code of Ordinances: Supplement 23).
Full Breakdown
Knox County adopted the 2018 edition of the National Fire Protection Association's Life Safety Code by reference in Sec. 30-56, then amended it in Sec. 30-57. 6 and NFPA 72 standards. The amendment specifies where smoke or heat detectors go depending on the area protected. In a residential area used for sleeping, detectors are required within every bedroom or sleeping room, centrally located in the corridor or area giving access to each group of sleeping rooms, and on every level of the residential apartment. In the building's other, non-residential occupancies, detection is required throughout, spaced to NFPA 72.
1, and the completed system must pass an acceptance test approved by the fire inspector. The rule targets apartment buildings, mixed residential/commercial structures, and other multi-occupancy buildings with sleeping units, rather than standalone single-family houses, which fall instead under the smoke-alarm provisions of the separately adopted International Residential Code. The amendment traces to Ord. No. O-18-10-101, § 14, adopted November 19, 2018, which repealed and reenacted Article III of Chapter 30 to update it from the 2012 to the 2018 LSC edition.
Violations & Fines
The Life Safety Code amendments are enforced by the Knox County Department of Codes Administration and Inspections, which reviews detector plans before permit issuance and requires a fire inspector's acceptance test on completion. Occupying a covered multi-occupancy building without the required alarm and detector installation is a Fire Code and Life Safety Code violation subject to the county's code enforcement and inspection process before a certificate of occupancy issues.
Frequently Asked Questions
Does Knox County require smoke detectors in every apartment?
Who reviews smoke detector plans for apartment buildings in Knox County?
Does this rule cover single-family houses?
Sources & Official References
Other rules in Knox County
Compare Knox County to another location·View the Tennessee fire regulations overview
See something wrong?
Help us keep this page accurate. If you notice an error or outdated information, let us know.