Sonoma County, CA Outdoor Lighting: Dark Sky Rules (2026)
Key Facts
- Maximum output
- 1,000 lumens per fixture
- Spill limit
- 1.0 lux total beyond the property line
- Flood lights
- Not allowed
- Security lighting
- Motion-sensor activated only
- Road, parking, driveway lights
- Low profile, full cut-off fixtures
- Where it applies
- LG/MTN combining zone, visible from public roads
- Existing homes
- Deemed compliant; expansions must comply
Summary
Homes and site development in Sonoma County's Taylor/Sonoma/Mayacamas Mountains (LG/MTN) combining zone must use downward-facing, fully shielded exterior lights capped at 1,000 lumens per fixture, with no more than 1.0 lux crossing the property line. Flood lights are prohibited, and any security lighting must be motion-sensor activated only.
d. Lighting, Exterior. 1. Exterior lighting shall be downward facing, fully shielded, and located at the lowest possible point to the ground to prevent glare and light pollution. 2. Light fixtures shall not be located at the periphery of the property and shall not spill over onto adjacent properties or into the night sky. 3. Luminaires shall have a maximum output of one thousand (1,000) lumens per fixture. 4. Total illuminance beyond the property line created by simultaneous operation of all exterior lighting shall not exceed one (1.0) lux. 5. All roadway, parking, and driveway lights shall be low profile utilizing full cut-off fixtures. 6. Flood lights are not allowed. 7. If security lighting is necessary, it shall be motion-sensor activated only.
Official source re-checked September 7, 2026: no newer edition of the code had been published (publisher’s edition: Code of Ordinances: Supplement 64 Update 2).
Full Breakdown
Section 26-90-120 of the Sonoma County Code sets the strictest night-sky standard in the county's zoning chapter, but it reaches only properties inside the LG/MTN (Local Guidelines/Taylor Sonoma Mayacamas Mountains) combining zone, as shown in the County's Zoning Database. Inside that boundary, the lighting rule sits in subsection (c)(2)d. under the Architectural Standards.
Seven separate limits apply. Exterior lighting must face downward, be fully shielded and sit at the lowest possible point to the ground to prevent glare and light pollution. Fixtures cannot be placed at the periphery of the property, and light cannot spill onto adjacent properties or into the night sky. Each luminaire is capped at one thousand (1,000) lumens per fixture. All exterior lighting operating at the same time cannot create more than one (1.0) lux beyond the property line. Roadway, parking and driveway lights must be low profile, full cut-off fixtures. Flood lights are not allowed at all. Any security lighting must be motion-sensor activated only.
The standards apply to single-family dwellings, residential accessory structures and associated site development such as roadways, grading and utilities, when those features are or would be visible from public roads. Exempt are accessory structures that need no Building Permit, agricultural structures and uses, farm family, agricultural employee and farmworker housing, and structures that are not or would not be visible from public roads at the time of construction. The section also states that it does not govern how a dwelling looks from a non-vehicular pedestrian, bicycle or equestrian trail open to the public.
The Department and the Board appointed local citizen advisory committees use these standards under Chapter 26, Article 64 (Scenic Resources Combining Zone) when they evaluate Building Permit applications for single-family dwellings and associated site development. A deed restriction must be recorded stating the conditions of the Design Review or Administrative Design Review approval, so the lighting limits follow the parcel to later owners. Legal dwellings and appurtenant structures that existed on the section's effective date are deemed to comply, but expansions must comply. The review authority can waive or modify one or more requirements only where strict compliance would render a legal parcel unbuildable. The current text reflects Ord. No. 6544 (12-9-2025) and Ord. No. 6532 (10-7-2025).
Violations & Fines
The section prints no separate fine schedule for lighting. Compliance is enforced through the Design Review or Administrative Design Review approval and the Building Permit review run by the Department with the local citizen advisory committee, and the approval conditions are recorded in a deed restriction on the parcel. A plan that shows flood lights, unshielded fixtures, luminaires above 1,000 lumens or spill beyond the property line fails the standard and cannot be approved as submitted. Only a finding that strict compliance would make the parcel unbuildable allows a waiver or modification.
Frequently Asked Questions
How bright can an exterior light be in Sonoma County's Mountain zone?
Can I install flood lights or a security light on my mountain property?
Do these lighting rules apply to my existing house?
Which properties are covered by Section 26-90-120?
Can the lighting requirements be waived?
Sources & Official References
Other rules in Sonoma County
California rules heatmap·Compare Sonoma County to another location·View the California outdoor lighting overview
See something wrong?
Help us keep this page accurate. If you notice an error or outdated information, let us know.