Fruitport Charter Township, MI Sign Regulations: Freeway-Facing Signs (2026)
Key Facts
- Where allowed
- Within 100 feet of I-96 and US 31 only
- Eligible districts
- B-2, B-3, B-4, SC-1 or M-1; PUD needs a variance
- Spacing between billboards
- 1,000 feet in the same direction of traffic
- Distance from homes
- 100 feet from residential districts, 500 feet from residences
- Panel limits
- No more than two panels; 672 square feet total area
- Permit
- Building permit with 80 mph wind load blueprint and engineer approval
Summary
Fruitport Charter Township allows billboards only within 100 feet of the I-96 and US 31 freeways, on property in B-2, B-3, B-4, SC-1 or M-1, with PUD land needing a variance. Each billboard carries spacing, setback, panel and permit rules set out in Code § 42-673(9).
(9) Notwithstanding any other provision of this article to the contrary, billboards (a large panel designed to carry outdoor advertising) shall be permitted within 100 feet of the 1-96 and US 31 freeways only, on property in B-2, B-3, B-4, SC-1 or M-1. Areas zoned PUD require variance approval. All billboards are subject to the following regulations: a. Billboard allowed only along US 31 and 1-96. b. Each billboard shall be located a minimum distance of 100 feet from residential zoning districts and a minimum distance of 500 feet from all existing residences. c. Each billboard shall be located a minimum distance of 1,000 feet from any other billboard facing the same direction of traffic on either side of the freeway. ... e. Each billboard shall have a minimum setback of two feet from the freeway right-of-way. ... g. No billboard shall contain more than one sign panel facing the same direction of traffic. h. No billboard shall contain more than two sign panels.
Full Breakdown
Section 42-673(9) of the Fruitport Charter Township Code controls freeway-facing advertising signs. It applies notwithstanding any other provision of the sign article and defines a billboard as a large panel designed to carry outdoor advertising. Billboards are permitted within 100 feet of the I-96 and US 31 freeways only, and only on property in the B-2, B-3, B-4, SC-1 or M-1 districts. Areas zoned PUD require variance approval. Subsection (9)a repeats the corridor limit: a billboard is allowed only along US 31 and I-96.
Spacing comes in three layers. Each billboard must sit at least 100 feet from residential zoning districts and at least 500 feet from all existing residences. It must sit at least 1,000 feet from any other billboard facing the same direction of traffic on either side of the freeway, and for that count the distance between billboards on opposite sides is measured between the points where lines drawn perpendicular to the freeway from each billboard meet the line along the center of the freeway. It must also be at least 100 feet from freestanding on-premises signs on the same side of the freeway that are visible from the traveled portion of the freeway, though the 1,000-foot billboard spacing governs between billboards.
Setbacks are two feet from the freeway right-of-way, plus two feet of distance for every one foot of overall height between the billboard and the nearest property line that intersects the property line abutting the freeway. A billboard may not contain more than one sign panel facing the same direction of traffic, and no more than two sign panels in all. Total sign panel area may not exceed 672 square feet, each panel may be no wider than 14 feet and no longer than 48 feet, and irregular extensions not exceeding four percent of a panel's area may extend past its perimeter.
No billboard can be erected without a building permit from the building inspection department. The application must include a blueprint with a minimum wind load rating of no less than 80 miles per hour and design approval by a state-licensed engineer.
Separately, section 42-673(8) permits sign boards or billboards as a principal use on unoccupied lots in the B-2 district at a ratio of two square feet of area for each foot of lot width, on lots at least 100 feet wide, not exceeding 300 square feet in area. Section 42-3 defines a billboard as a structure displaying advertising unrelated to the premises or the business conducted there. These rules apply in Fruitport Charter Township, outside the Village of Fruitport.
Violations & Fines
Erecting a billboard without the building inspection department's permit, outside the 100-foot freeway band, in a district other than B-2, B-3, B-4, SC-1 or M-1, or without the 80 mile-per-hour wind load blueprint and state-licensed engineer approval breaks § 42-673(9). Section 42-673(9) prints no fine of its own, so the township's general enforcement provisions for the zoning chapter apply.
Frequently Asked Questions
Where can a billboard be built in Fruitport Township?
How far apart must freeway billboards be?
How big can a Fruitport billboard be?
What does a billboard permit application require?
Sources & Official References
Other rules in Fruitport Charter Township
Compare Fruitport Charter Township to another location·View the Michigan sign regulations overview
See something wrong?
Help us keep this page accurate. If you notice an error or outdated information, let us know.