Skip to main content

Alpine, TX Sign Regulations: Window Signs (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified November 2026

Key Facts

Window coverage cap
25 percent of the window area where displayed
Lighting
Window signs must not be illuminated
Where permitted
Nonresidential uses in residential districts; all commercial and industrial districts
Divided windows
Panels separated by muntins or mullions count as one continuous window
Other sign allowances
Window signs are not assessed against other sign types
Maximum penalty
Fine not to exceed $2,000.00 per day

Summary

Alpine, Texas exempts non-illuminated window signs, show cards and bulletins from the sign chapter for nonresidential uses in residential districts and for all commercial and industrial districts. The aggregate area of window signs cannot exceed 25 percent of the window area on which they are displayed, and window signs do not count against other sign allowances.

(b) Exempt signs. The following signs shall be exempt from the provisions of this chapter. ... (14) Window signs, show cards and bulletins, as long as such signs are not illuminated. Window signs shall be permitted for any nonresidential use in a residential district, and for all commercial and industrial districts, subject to the following limitations: a. The aggregate area of all such signs shall not exceed 25 percent of the window area on which such signs are displayed. Window panels separated by muntins or mullions shall be considered to be one continuous window area. b. Window signs shall not be assessed against the sign area permitted for other sign types.

Full Breakdown

Window signs are regulated in section 78-3(b)(14) of the Alpine Code, in the list of exempt signs. Section 78-1 defines a window sign as a sign affixed to the surface of a window with its message intended to be visible to and readable from the public way or from adjacent property. The rule allows window signs, show cards and bulletins as long as they are not illuminated, and it names where they are permitted: any nonresidential use in a residential district, and all commercial and industrial districts.

Two limitations apply. First, the aggregate area of all such signs shall not exceed 25 percent of the window area on which the signs are displayed. Second, window panels separated by muntins or mullions are treated as one continuous window area, so a storefront divided into small panes is measured as a single window instead of pane by pane. The cap is a share of the window, not a fixed square foot figure.

The allowance is also separate from the rest of a business's sign budget. Section 78-3(b)(14)b says window signs shall not be assessed against the sign area permitted for other sign types, which means a window display does not reduce the area available for a wall sign or freestanding sign on the same premises.

The no-illumination condition ties into other prohibitions. Section 78-3(a)(3) bans signs that blink, flash or are animated by lighting so as to look like traffic safety signs and lights, and section 78-2(f)(2) lists all illuminated signs among those needing a permit. Section 78-3(b) exempts the listed signs from the provisions of the sign chapter, and the code enforcement officer or agency representative enforces the chapter under section 78-5.

Violations & Fines

Section 78-5(b) makes each day or part of a day a violation is committed, continued or permitted a separate offense, punishable on conviction by a fine not to exceed $2,000.00. Under section 78-5(a)(1), the code enforcement officer or agency representative gives written notice to the permittee or property owner, and the sign must be removed or altered within ten days after mailing or the city may remove it at the owner's expense. Section 78-3(a)(16) also lists any sign in obvious poor repair among prohibited signs, with an appeal to the planning and zoning commission.

Frequently Asked Questions

How much of a storefront window can be covered by signs in Alpine?
Section 78-3(b)(14)a limits the aggregate area of all window signs to 25 percent of the window area on which they are displayed. Window panels separated by muntins or mullions are treated as one continuous window area for that measurement.
Can I light up a window sign in Alpine?
No. Section 78-3(b)(14) allows window signs, show cards and bulletins only as long as they are not illuminated. Section 78-2(f)(2) also puts all illuminated signs on the list of signs that need a permit, and section 78-3(a)(3) bans blinking, flashing or animated lighting that resembles traffic safety signals.
Do window signs count against my wall or freestanding sign allowance?
No. Section 78-3(b)(14)b says window signs shall not be assessed against the sign area permitted for other sign types. The 25 percent window cap is a separate limit that applies only to the window on which the signs are displayed.
Which zones allow window signs in Alpine?
Section 78-3(b)(14) permits window signs for any nonresidential use in a residential district and for all commercial and industrial districts. The text does not list window signs for a purely residential use, and section 78-1 defines a window sign as one affixed to the surface of a window.

Sources & Official References

Other rules in Alpine

All Alpine rules

Texas rules heatmap·Compare Alpine to another location·View the Texas sign regulations overview

Get notified when Window Signs in Alpine, TX changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.