Seaside, OR Building Setbacks & Zoning: Lot Coverage Limits (2026)
Key Facts
- R-1 lot coverage
- 35 percent of the total area of the lot
- R-2 and Residential-Commercial
- 40 percent of the total area of the lot
- R-3 lot coverage
- 55 percent of the total area of the lot
- EFU lot coverage
- 35 percent of the total area of the lot
- C-1, C-2, C-3
- No lot coverage requirement
- Counted toward the cap
- Permitted structure and accessory buildings
- Penalty
- Up to 30 days or $150.00 fine, each day separate
Summary
In Seaside's R-1 low density zone, the area covered by a permitted structure and accessory buildings cannot exceed 35 percent of the total lot area. Zoning Ordinance 83-10 sets 40 percent in R-2, 55 percent in R-3, and no requirement in the C-1, C-2 and C-3 commercial zones.
Section 3.025 Standards. ... In the R-1 Zone the following standards shall apply: ... 7. Lot Coverage: Maximum area that may be covered by a permitted structure and accessory buildings shall not exceed 35 percent of the total area of the lot.
Full Breakdown
Section 3.025(7) of the R-1 Residential Low Density zone caps the maximum area that can be covered by a permitted structure and accessory buildings at 35 percent of the total area of the lot. Accessory buildings count toward the cap, so a garage or shed on an R-1 lot uses part of the same allowance as the house.
The cap sits next to the other R-1 standards in the same section: a minimum lot area of 10,000 square feet, an average lot width of at least 70 feet at the building line, a density of no more than five dwelling units per net acre, a 20-foot front yard, a five-foot side yard, a 15-foot rear yard and a 35-foot height limit. Section 3.025 also sends off-street parking to Section 4.100 and requires every use to comply with the supplementary provisions in Article 4.
Other zones in Ordinance 83-10 print their own percentages. The R-2 Residential Medium Density zone allows 40 percent, and so does the Residential-Commercial zone. The R-3 Residential High Density zone allows 55 percent of the total area of the lot. The EFU farm zone matches R-1 at 35 percent. The Resort Residential zone prints no lot coverage item in its standards. The C-1, C-2 and C-3 commercial zones each print no requirement for lot coverage, although C-2 and C-3 still require yards where a lot abuts an R zone.
The code states lot coverage as a share of total lot area, so the percentage applies to the whole lot rather than to the buildable area left after yards. An owner who needs more coverage than the zone permits can apply to the Planning Director for a variance under Section 7.020, which requires special and unusual circumstances tied to a specific piece of property and an undue or unnecessary hardship. Section 10.037 allows an appeal of that ruling to the Planning Commission within 15 days.
Violations & Fines
Section 12.010 of the Seaside Zoning Ordinance punishes a violation, on conviction, by imprisonment for not more than thirty days, a fine of not more than $150.00, or both, and each day the violation continues is a separate offense. Section 12.020 makes a building in violation a nuisance that the City can enjoin, abate or remove, and Section 10.020 bars the Building Official from issuing a permit for a nonconforming structure.
Frequently Asked Questions
What share of an R-1 lot in Seaside can be built on?
Do sheds and garages count toward Seaside's lot coverage limit?
Is lot coverage limited in Seaside's commercial zones?
How can a Seaside owner exceed the lot coverage percentage?
Sources & Official References
Other rules in Seaside
Compare Seaside to another location·View the Oregon building setbacks & zoning overview
See something wrong?
Help us keep this page accurate. If you notice an error or outdated information, let us know.