Building Setbacks & Zoning in Bristol Township, PA (2026)
3 verified building setbacks & zoning rules for Bristol Township, Pennsylvania, sourced directly from the municipal code and official government pages.
Verified from official government sources
Setback Rules
In Bristol Township, Pennsylvania, a lot in the R-1 Residence District needs a 35-foot front yard, a 25-foot rear yard, and two side yards that total 30 feet with neither under 12 feet. Corner and double frontage lots carry two 35-foot front yards. The denser R-2, R-3 and R-4 districts set smaller minimums.
Bristol Township PA Yard Setback Minimums by Zone
Some RestrictionsBristol Township Code § 205-23
§ 205-23. Area and dimensional requirements. ... Unless a greater area or dimensional requirement is listed in Article III, Use Regulations, for a specific use, all uses in the R-1 District shall meet the following requirements: ... E. Minimum yards: (1) Front: 35 feet. (2) Side: two yards with aggregate width of 30 feet, neither less than 12 feet. (3) Rear: 25 feet. (4) Corner lot: two front y...
Structure Height Limits
In Bristol Township, Pennsylvania, every residence district caps building height at 35 feet: R-1, R-2, R-3 and R-4 each print the same limit in their area and dimensional section. Section 205-135 exempts only listed items such as spires, silos and antennas, and only when they are set back 1.5 times their height from every property line.
Bristol Township PA Residential Building Height Limits
Some RestrictionsBristol Township Code § 205-26
§ 205-26. Area and dimensional requirements. ... Unless a greater area or dimensional requirement is listed in Article III, Use Regulations, for a specific use, all uses in the R-2 District shall meet the following requirements: ... F. Maximum height: 35 feet.
Lot Coverage Limits
In Bristol Township's R-1 Residence District, maximum building area is 20% and the maximum impervious surface ratio is 30%. Neighboring residential districts allow more: 25% and 35% in R-2, and 30% and 40% in R-3, unless a specific use in Article III sets a greater requirement.
Bristol Township R-1 Lot Coverage Limits
Some RestrictionsBristol Township Code § 205-23
§ 205-23. Area and dimensional requirements. Unless a greater area or dimensional requirement is listed in Article III, Use Regulations, for a specific use, all uses in the R-1 District shall meet the following requirements: A. Minimum lot area: 10,000 square feet. B. Minimum lot width: 75 feet. C. Maximum building area: 20%. D. Maximum impervious surface ratio: 30%.
Looking for Bucks County county-wide rules?
County ordinances apply to unincorporated areas and may supplement Bristol Township city rules.
Building Setbacks & Zoning in Bucks County →