Skip to main content
CityRuleLookup

Fence Regulations in Rockwall, TX (2026)

3 verified fence regulations for Rockwall, Texas, sourced directly from the municipal code and official government pages.

Verified from official government sources

Height Limits

Rockwall caps fence height at 2 feet inside the corner-lot visibility triangle to keep sightlines open for traffic.

Rockwall Corner Fence Height Limit

Some Restrictions

Sec. 26-2(g)

It shall be unlawful for any person to construct or replace, or cause to be constructed or replaced, any fence having a height greater than two feet above the level of the center of the nearest abutting street on or in the triangle described in subsection (b) of this section; provided this section will not apply to any fence authorized by law.

Fence Permit Requirements

Rockwall requires a building permit for every fence built in the city, with a final inspection by the building official before the permit is closed out.

Rockwall Fence Permit & Inspection Rule

Some Restrictions

Sec. 10-446

Upon completion of a fence constructed under a permit issued by the building official, an inspection shall be made thereof by the building official or his designated representative. If the fence is constructed in accordance with the provisions of this article, the permit, and the application, the building official will issue written notice of acceptance to the permit holder. Any and all fences ...

Retaining Walls

Rockwall requires a building permit for every retaining wall, restricts them to masonry, stone, or reinforced concrete with a stone face or form liner, bans smooth concrete, and requires a Texas-licensed engineer's seal above 3 feet.

Rockwall Retaining Wall Permit and Material Rules

Some Restrictions

Sec. 10-138

Section R404.4 Retaining walls. All retaining walls require a permit. Retaining walls must be masonry, stone, or reinforced concrete with stone face/form liner. Smooth concrete retaining walls shall not be installed. Retaining walls exceeding 3 feet in height must be designed and sealed by a Texas-licensed engineer. Add section R703.8.4.1.2 Veneer Ties for Wall Studs; to read as follows: R703...