Skip to main content
CityRuleLookup

St. Louis County, MO Tree Protection: Parkway Planting (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified September 2026

Key Facts

Single-family ratio
1 tree per lot
Corner lots
1 tree per street frontage
Common/multi-family land
1 tree per 50 ft frontage
Minimum caliper
1.5 inches
Species cap
40% of one species per plat
Curb setback
no closer than 3 feet
Exemption
lots with 150+ ft frontage

Summary

New subdivisions in unincorporated St. Louis County must plant at least one street tree per lot, and two on corner lots, under Section 1005.340 of the Subdivision Ordinance. Common land, multi-family, and nonresidential subdivisions need one tree per 50 feet of street frontage, each at least 1.5 inches in caliper, with no more than 40 percent of one species per plat.

City-specific rules exist: Florissant has its own parkway planting rules that differ from St. Louis County's county-level regulations. If you live in Florissant, check the city-specific page instead.

2. Required street trees. For all single-family residential subdivisions there shall be a minimum of one (1) tree for every lot; in cases of lots having frontage of more than one (1) street (e.g. corner lots) there shall be a minimum of one (1) tree for each street on which the lot has frontage. For common land, multiple-family residential subdivisions, and nonresidential subdivisions, there shall be a minimum ratio of one (1) tree for every fifty (50) feet of street frontage. Each tree shall be at least one and one-half (1½) inches in caliper. A maximum of forty (40) percent of one species may be utilized to meet planting requirements within each plat of a subdivision. Street trees shall not be required for large lot subdivisions or for subdivisions in the Non-Urban District utilizing the density development procedure on lots having frontages of one hundred fifty (150) feet or greater. (a) Location. ... Street trees shall not be planted closer than three (3) feet to any curb.

View official code

Official source re-checked September 7, 2026: no newer edition of the code had been published (publisher’s edition: Code of Ordinances: Supplement 85 | Traffic: Supplement 80).

Full Breakdown

340 requires a subdivision landscape plan covering the area outside individual residential setbacks to be submitted to the Department of Planning before the record plat, showing the type, size, and location of all proposed and existing plantings. 380, and they cannot be planted within three feet of a curb, within 25 feet of street lights if placed by variance in the right-of-way, within the sight-distance triangle at intersections, or within ten feet of a street inlet or manhole. Hardwood species must come from an approved list the Department of Planning maintains, and a developer may substitute an alternate landscape plan for the required street trees if the Department approves it.

Large-lot subdivisions and Non-Urban District subdivisions using the density development procedure on lots with 150 feet or more of frontage are exempt from the street tree requirement entirely. The Department of Transportation and Public Works must separately approve any structures or plantings proposed at a subdivision entrance, may require sodding or other erosion-control ground cover, and the Department may also require clearing of underbrush and additional landscaping in common land that has been altered by grading.

Violations & Fines

Compliance with Section 1005.340 is checked by the Department of Planning during subdivision plat review, and a record plat will not be approved and recorded until the landscape plan and required street trees meet these standards or an approved alternate plan or Section 1005.380 variance is in place. Because the requirement attaches to the plat approval process rather than a standalone citation scheme, the enforcement tool is withholding plat recordation rather than a per-tree fine.

Frequently Asked Questions

How many street trees does a new subdivision have to plant?
Section 1005.340 requires a minimum of one tree per lot in single-family subdivisions, with an extra tree for each street a corner lot fronts. Common land, multi-family, and nonresidential subdivisions instead need one tree for every 50 feet of street frontage, each at least 1.5 inches in caliper.
Where can street trees be placed under the subdivision rule?
Trees must go in front of the setback line and stay out of the street right-of-way unless a variance is approved. They cannot be planted closer than three feet to a curb, within 25 feet of street lights, inside the sight-distance triangle at intersections, or within ten feet of a street inlet or manhole.
Are any subdivisions exempt from the street tree requirement?
Yes. Section 1005.340 exempts large-lot subdivisions and Non-Urban District subdivisions using the density development procedure on lots with frontages of 150 feet or more. A developer may also substitute an alternate landscape plan for the Department of Planning's approval instead of planting the required street trees.
Can a developer use one tree species throughout a subdivision?
No. Section 1005.340 caps any single species at 40 percent of the trees used to meet the planting requirement within each plat, and all hardwood trees must come from the acceptable species list the Department of Planning maintains.

Sources & Official References

Other rules in St. Louis County

All St. Louis County rules

Compare St. Louis County to another location·View the Missouri tree protection overview

Get notified when Parkway Planting in St. Louis County, MO changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.

Parkway Planting in Cities Across St. Louis County