Skip to main content
CityRuleLookup

San Jacinto, CA Building Safety: Door Locking Hardware (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified October 2026

Key Facts

Dead-bolt
Single-cylinder, minimum one inch throw, with key in knob dead-latch
Strike plate
Minimum 16 U. S. gauge steel, bronze, or brass, anchored two inches
Master keying
Prohibited unless the condominium association requests it
Glazing near locks
Tempered or burglary-resistant within 40 inches of a lock
Sliding doors
Slide dead bolt at both top and bottom
Applies to
Residential condominiums, new and converted

Summary

In the City of San Jacinto, California, every new residential condominium and every conversion must put a single-cylinder dead-bolt with a one inch throw on exterior doors and on doors from the garage into a unit. Strike plates, hinge pins and unit keying are regulated too, under San Jacinto Municipal Code § 17.410.050.

Keying requirements. Each single dwelling unit shall have locks using combinations that are interchange-free from locks used in all other separate dwellings (i.e., master keying is prohibited). Master keying may be allowed when requested by the condominium association authorized to represent the owners of the condominium units within the project. ... Exterior doors and doors leading from garage areas into private units shall be ... equipped with a single-cylinder, dead-bolt lock with a minimum one inch throw, working in concert with a key in knob dead-latch mechanism, except for sliding glass doors and the stationary door of a double door entry which shall be provided with a slide dead bolt at both top and bottom. ... The strike plate for dead bolts on all wood frame doors shall be constructed of minimum 16 U. S. gauge steel, bronze, or brass anchored two inches into solid backing beyond the surface to which the strike plate is attached. ... Hinges for out-swinging doors shall be equipped with non-removable hinge pins or a mechanical interlock to preclude removal of the door from the exterior by the removal of its pins.

Full Breakdown

The door hardware rules sit in the Development Code chapter on condominiums, not in a stand-alone security ordinance, so they bind the City Council's condominium approvals in the City of San Jacinto (Riverside County, California). Chapter 17.410 applies to a residential condominium or other common interest development created with a new structure and to the conversion of an existing structure. Commercial condominiums are excluded and fall to the California Department of Real Estate. Section 17.410.050 states that its standards cover both new condominiums and conversions.

For locks, exterior doors and doors leading from garage areas into private units need a single-cylinder dead-bolt with a minimum one inch throw, working together with a key in knob dead-latch mechanism. Sliding glass doors and the stationary leaf of a double door entry instead take a slide dead bolt at both top and bottom. On wood frame doors the dead-bolt strike plate must be at least 16 U. S. gauge steel, bronze or brass, anchored two inches into solid backing beyond the surface it is attached to. Hinges on out-swinging doors need non-removable hinge pins or a mechanical interlock so the door cannot be lifted off from outside.

The same subsection regulates the frame. Jambs get solid backing with no voids for a vertical distance of at least six inches each side of the strike, and wood framing gets horizontal blocking at door lock height for three stud spaces each side of the opening. Glazing in an exterior door, or within 40 inches of any locking mechanism, must be fully tempered or burglary-resistant glass unless double-cylinder dead-bolt locks are installed. Front exterior doors need a 180 degree viewer unless clear vision panels are installed. Sliding glass windows and doors need locks that resist 500 pounds of pry force.

Keying is a separate rule: each dwelling unit has locks that are interchange-free from every other dwelling, so master keying is prohibited. The condominium association authorized to represent the unit owners can request master keying, and then it is allowed.

Violations & Fines

Section 17.410.050 prints no penalty of its own, so the citywide enforcement chapters apply. Under § 1.24.020 a misdemeanor conviction carries a fine of not more than $1,000, or imprisonment not to exceed six months, or both. Under § 1.24.030 an infraction costs up to $100 for a first violation, up to $200 for a second within one year, and up to $500 for each additional one. Each day is a separate offense under § 1.24.040, and § 1.28.030 lets an enforcement officer issue an administrative citation.

Frequently Asked Questions

Do San Jacinto single-family homes have to meet these lock standards?
No. Section 17.410.050 sits in the chapter on residential condominiums and other common interest developments, whether newly built or converted from an existing structure. It does not set door lock rules for detached houses in the City of San Jacinto, and commercial condominiums are excluded by § 17.410.020 and left to the California Department of Real Estate.
What kind of dead-bolt does San Jacinto require on condominium doors?
A single-cylinder dead-bolt lock with a minimum one inch throw, working in concert with a key in knob dead-latch mechanism. It goes on exterior doors and on doors leading from garage areas into private units. Sliding glass doors and the stationary door of a double door entry take a slide dead bolt at the top and bottom instead.
Can a condominium project in San Jacinto use master keys?
Each dwelling unit must have locks on combinations interchange-free from all other dwellings, so master keying is prohibited. The one exception in § 17.410.050 is a request from the condominium association authorized to represent the owners of the units in the project, which allows master keying.
What are the door frame and hinge requirements?
Jambs need solid backing for at least six inches each side of the strike, and wood framing needs horizontal blocking at lock height for three stud spaces each side. Out-swinging doors need non-removable hinge pins or a mechanical interlock. In-swinging exterior doors need door stops and wooden jambs made of a single piece of material.

Sources & Official References

Other rules in San Jacinto

All San Jacinto rules

California rules heatmap·Compare San Jacinto to another location·View the California building safety overview

Get notified when Door Locking Hardware in San Jacinto, CA changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.

Door Locking Hardware in Nearby Cities

How other cities in Riverside County handle door locking hardware.

Palm Springs, CA
Some Restrictions