Skip to main content
CityRuleLookup

Bannock County, ID Building Setbacks & Zoning: Setback Rules (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified September 2026

Key Facts

House, local road
30 feet minimum
House, arterial/collector road
50 feet minimum
House, rear/side yard
30 ft rear, 20 ft side
Farm animal structures
100 feet on every side
Stream/riparian setback
100 feet, all structures
Governing section
Bannock County Code Section 17.12.060

Summary

In the Agricultural district of unincorporated Bannock County, a single-family residence must sit at least 30 feet from a local road right-of-way, 50 feet from an arterial or collector road, 30 feet from the rear property line and 20 feet from the side. Bannock County Code Section 17.12.060 sets these minimums for permitted uses.

These county ordinances apply to unincorporated areas of Bannock County. Incorporated cities within the county may have their own rules that take precedence over county-level regulations.

AGRICULTURAL DISTRICT Minimum Setbacks (feet) (1)

From Local Road R-O-W From Arterial or Collector Road R-O-W Rear Yard Side Yard

Permitted Uses: Single-family residence 30 50 30 20

Full Breakdown

Bannock County Code Section 17.12.060 publishes a building bulk and placement table for the Agricultural (A) district that fixes minimum setbacks by road type and lot line. A single-family residence needs 30 feet from a local road right-of-way, 50 feet from an arterial or collector road right-of-way, 30 feet from the rear yard line, and 20 feet from the side yard line. Residential accessory structures and accessory structures for commercial agriculture share the same 30-foot local road and 50-foot arterial setback but only need 15 feet on the rear and 20 feet on the side.

Accessory structures built for commercial agriculture farm animals, such as barns or confinement buildings, must clear 100 feet on every side: local road, arterial road, rear yard and side yard alike. A footnote to the table adds a stricter rule that overrides all of the above near water: every structure in the A district must sit at least 100 feet from any stream or riparian area, with an exception only for approved culverts that meet Bannock County Planning and Development Services standards and the requirements of any other agency with jurisdiction.

Minimum lot size in the A district is one acre, with density limited to one dwelling per 40 acres under Section 17.12.050, and conditional uses in the district have their setbacks determined case by case by the Planning and Development Council rather than by the fixed table. The health department can also require larger lot sizes than the zoning minimum where septic or water supply conditions call for it.

Violations & Fines

Building a structure closer to a road, property line or riparian area than Section 17.12.060 allows in the Agricultural district requires Planning and Development Services to withhold or revoke site plan approval, and an as-built survey that shows a setback violation can block issuance of a certificate of occupancy until the structure is moved, removed or a variance is obtained through the Planning and Development Council.

Frequently Asked Questions

How far must my house be from the road in the Agricultural district?
At least 30 feet from a local road right-of-way and 50 feet from an arterial or collector road right-of-way, under Bannock County Code Section 17.12.060. Rear yard setback is 30 feet and side yard setback is 20 feet for a single-family residence.
Are barns held to the same setback as my house?
No. Ordinary residential accessory structures share the house's 30-foot local road and 50-foot arterial setbacks but only need 15 feet on the rear and 20 feet on the side. Structures built for commercial agriculture farm animals need a full 100 feet on every side instead.
Can I build close to a creek on agricultural land?
No. A footnote to Section 17.12.060 requires every structure in the Agricultural district to stay at least 100 feet from any stream or riparian area, with an exception only for approved culverts that meet Planning and Development Services standards and other agencies' requirements.

Sources & Official References

Other rules in Bannock County

All Bannock County rules

Compare Bannock County to another location·View the Idaho building setbacks & zoning overview

Get notified when Setback Rules in Bannock County, ID changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.