Skip to main content

Alpine, TX Building Setbacks & Zoning: Structure Height Limits (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified November 2026

Key Facts

R-1 height maximum
2½ stories or 35 feet
R-2 height maximum
2½ stories or 35 feet
R-3 height maximum
3 stories or ≤ 45 feet
Accessory buildings and carports
Cannot exceed height or bulk of primary structure
Towers above district height
Council-approved variance required
Where it is printed
Alpine Code Appendix C, Article I, Section II

Summary

In Alpine, a site in the R-1 one-family district is capped at 2½ stories or 35 feet. R-2 duplex, townhouse, triplex and quadplex sites carry the same cap, and R-3 apartment sites rise to 3 stories or 45 feet. Accessory buildings and carports on an R-1 lot cannot exceed the height or bulk of the primary structure.

Each site in the R-1 district shall be subject to the following site development regulations: Feature Regulations Lot width minimum 50 feet Height maximum 2½ stories or 35 feet ... Temporary/accessory building or structures ≤ 40% of required rear yard not to exceed height or bulk of primary structure Home occupations Section 8 Carports ≤ 40% of required front/side/rear yard not to exceed height or bulk of primary structure

Full Breakdown

Appendix C of the Alpine Code of Ordinances sets a site development table for each zoning district. For the R-1 one-family district, the height line reads 2½ stories or 35 feet. The table sits in Section II of Article I, applies to each site in the district, and follows a purpose clause describing R-1 as a zone for low density living where single-family residential (detached) and local utility service are the base uses.

The same table also limits the secondary structures on an R-1 lot. A temporary or accessory building or structure is held to no more than 40% of the required rear yard and cannot exceed the height or bulk of the primary structure. A carport is held to no more than 40% of the required front, side or rear yard and carries the same ceiling: it cannot exceed the height or bulk of the primary structure. In practice that ties every garage, shed and carport on a one-family lot to the house it serves.

The neighboring residential districts print their own height lines. The R-2 multi-family table, written for duplexes, townhouses, triplexes and quadplexes, also prints 2½ stories or 35 feet. The R-3 apartment table, written for apartment houses and multiple family dwellings, prints 3 stories or ≤ 45 feet, and it adds that R-3 apartment use requires submittal of architectural plans.

Section VIII of Appendix C adds one height exception outside the district tables: radio or television towers or necessary mechanical appurtenances can be erected to a height exceeding the limit only in accordance with ordinances the city adopts later and only accompanied by a variance approved by the city council. The historic overlay area adds approval steps for signs but does not print a separate height figure.

Violations & Fines

The R-1 table prints no penalty of its own, so a structure taller than 2½ stories or 35 feet, or an accessory building or carport that exceeds the height or bulk of the primary structure, is a departure from the district regulation that the city handles through its building permit and zoning process. A tower or appurtenance above the district height needs the city council variance described in Section VIII.

Frequently Asked Questions

How tall can a house be in Alpine's R-1 district?
The R-1 site development table in Appendix C lists a height maximum of 2½ stories or 35 feet. R-1 is the one-family district for single-family residential (detached) homes, and the table applies to each site in the district.
Can a garage or shed in Alpine be taller than the house?
No. On an R-1 lot, a temporary or accessory building or structure cannot exceed the height or bulk of the primary structure, and it is also held to no more than 40% of the required rear yard. Carports follow the same height and bulk ceiling.
Is the height limit higher for apartments in Alpine?
Yes. The R-3 apartment district table prints 3 stories or ≤ 45 feet, compared with 2½ stories or 35 feet in R-1 and R-2. R-3 apartment use also requires submittal of architectural plans.
Does Alpine allow towers above the district height?
Section VIII of Appendix C says radio or television towers or necessary mechanical appurtenances can exceed the district height only in accordance with ordinances the city adopts later and only with a variance approved by the city council.

Sources & Official References

Other rules in Alpine

All Alpine rules

Texas rules heatmap·Compare Alpine to another location·View the Texas building setbacks & zoning overview

Get notified when Structure Height Limits in Alpine, TX changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.