Skip to main content

Murray, KY Building Setbacks & Zoning: Structure Height Limits (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified November 2026

Key Facts

R-1 and R-2 maximum height
35 feet
R-3, R-3A, R-4, R-5 maximum height
35 feet
Industrial district (§ 156.039)
75 feet
Agricultural district (§ 156.042)
No limitation
Height measured
From mean grade at front building line to highest point
Relief
Dimensional variance, Board of Zoning Adjustments

Summary

Murray caps building height at 35 feet in every residential district: R-1, R-2, R-3, R-3A, R-4 and R-5. The limit appears in the lot, yard, and height regulations of the Chapter 156 zoning code. Height is measured from the established mean grade at the front building line to the highest point of the building.

(F) Lot, yard, and height regulations. ... (7) Maximum height. R-1 and R-2 - 35 feet. (8) Accessory buildings are permitted only in rear yards and shall be located at least five feet from all lot lines except on corner lots where secondary yard restrictions will apply.

Full Breakdown

Section 156.035(F)(7) of the Murray Code of Ordinances reads: Maximum height. R-1 and R-2 - 35 feet. The multi-family districts use the same figure. Section 156.036(F)(7) sets 35 feet for R-3, R-3A, R-4 and R-5. So a single-family house, a duplex and a four-unit building all face one ceiling across the residential zones.

The definition in § 156.004 controls how the 35 feet is measured. BUILDING HEIGHT is the vertical distance measured from the established mean grade at the front building line to the highest point of the building. The measurement starts at the front building line, not at the lowest corner of a sloping lot.

Other districts differ, and the numbers are printed in the code. The Professional Office district in § 156.038 caps height at 35 feet, the Industrial district in § 156.039 at 75 feet, and the Agricultural district in § 156.042 prints No limitation. The business districts in § 156.037 carry a 35 foot figure on their maximum height of any portion of a building lines.

Accessory structures sit beside the principal height rule. Under § 156.035(F)(8), accessory buildings are permitted only in rear yards and at least five feet from all lot lines, except on corner lots where secondary yard restrictions apply. Section 156.011(C) adds that an accessory building in a residential zone shall not exceed the total square footage of the building to which it is accessory.

The Board of Zoning Adjustments is the relief path. Section 156.082(A) gives it power to hear dimensional variances, defined to cover the height or width of building or size of yards, and § 156.082(B) requires findings that the variance will not adversely affect public health, safety or welfare or alter the essential character of the general vicinity. Section 156.082(E) says a variance runs with the land.

Violations & Fines

A structure built above the limit violates the zoning code under § 156.999(A), and a separate civil fine is assessed for each day the violation continues. The § 40.15 schedule for the Zoning Ordinance sets uncontested fines of $150, $200 and $500 for the first, second and each additional offense, and the Code Enforcement Board can impose $200 to $500 on a contested citation. Section 156.082(C) directs the Board to deny a variance arising from willful violations.

Frequently Asked Questions

How tall can a house be in Murray's R-1 and R-2 districts?
Section 156.035(F)(7) sets maximum height at 35 feet for both R-1 and R-2. The measurement runs from the established mean grade at the front building line to the highest point of the building, as defined in § 156.004.
Is the height limit different for apartments in Murray?
No. Section 156.036(F)(7) caps R-3, R-3A, R-4 and R-5 at 35 feet, the same number as the single-family districts. Multi-family districts differ on lot coverage, which is 50%, not on height.
How does Murray measure building height?
Section 156.004 defines BUILDING HEIGHT as the vertical distance measured from the established mean grade at the front building line to the highest point of the building. The reference point is the front building line, so confirm the mean grade with the Zoning Official before drawing plans.
Can I get a variance for extra height?
The Board of Zoning Adjustments can grant one under § 156.082, which covers the height or width of building or size of yards. It must find no adverse effect on public health, safety or welfare and no change to the essential character of the vicinity. The variance runs with the land.
Is there any Murray zone with no height cap?
Yes. Section 156.042(F)(6) prints Maximum height. No limitation. for the Agricultural district. The Industrial district in § 156.039 prints 75 feet, and the Professional Office district in § 156.038 prints 35 feet.

Sources & Official References

Other rules in Murray

All Murray rules

Compare Murray to another location·View the Kentucky building setbacks & zoning overview

Get notified when Structure Height Limits in Murray, KY changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.