Skip to main content
CityRuleLookup

Goodyear, AZ Outdoor Lighting: Light Trespass & Shielding (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified September 2026

Key Facts

Zone 1 perimeter cap
0.30 lumens/sq ft max
Zone 2 perimeter cap
0.80 lumens/sq ft max
Measured at
6 ft above grade
Enforced by
Planning & Zoning staff
CO withheld until
lighting brought into compliance

Summary

Goodyear's Outdoor Lighting article makes property owners responsible for keeping installed lighting from crossing onto a neighbor's land, backed by a perimeter illuminance cap near residential lots and a Certificate of Occupancy hold for noncompliant installations.

Planning & Zoning staff shall place a limitation on the on-site horizontal average illuminance for all projects, and the perimeter vertical illuminance when the site is within one hundred and fifty (150) feet of a residential property line. ... After lighting installation according to the approved plans, a property owner is responsible for ensuring that no lighting trespasses outside of the boundary of the property or lot and that no lighting from said property or lot causes a nuisance. If it is determined that there is lighting trespass or a nuisance related to lighting, the property owner is responsible for implementing a correction to come into compliance with the provisions of this section.

Full Breakdown

5, Outdoor Lighting, is administered by Planning & Zoning staff, who set a limitation on the on-site horizontal average illuminance for every project and a separate perimeter vertical illuminance limit whenever a site sits within 150 feet of a residential property line, calculated as an initial maximum value 6 feet above finished grade. 80. Fixture mounting heights are similarly tied to distance from a residential lot line, for example Zone 2 fixtures within 30 feet of a residential property line cannot exceed six feet, and must be full-cutoff once they clear 30 feet while remaining within 150 feet of that line.

Before a project can open, all outdoor lighting installations are subject to inspection and verification by Planning & Zoning staff, and the city can decline to issue the final Certificate of Occupancy or Certificate of Completion until an installation matches the approved plans. Once a project is occupied, the trespass rule shifts to the owner: the property owner is responsible for ensuring no lighting trespasses outside the boundary of the property or lot and that no lighting from the property causes a nuisance, and must correct the installation if trespass or a nuisance is confirmed.

Violations & Fines

Planning & Zoning staff can withhold the final Certificate of Occupancy or Certificate of Completion until a noncompliant lighting installation is corrected to match the approved plan. After occupancy, if inspection or a complaint confirms light is trespassing past the lot line or creating a nuisance, the owner must correct the installation to come back into compliance.

Frequently Asked Questions

What counts as light trespass under Goodyear's zoning code?
Section 4.5 makes the property owner responsible for ensuring no lighting trespasses outside the boundary of the property or lot once a lighting plan is installed, and requires a correction any time inspection or a complaint confirms trespass or a lighting nuisance.
How bright can a fixture be near my property line?
It depends on the lighting zone. The city's Lighting Standards Matrix caps perimeter vertical illuminance at 0.30 maintained lumens per square foot in Zone 1 and 0.80 in Zone 2, measured at an initial value 6 feet above finished grade within 150 feet of a residential property line.
Who inspects outdoor lighting for compliance?
Planning & Zoning staff verify every outdoor lighting installation against the approved plan before releasing a final Certificate of Occupancy or Certificate of Completion, and can require corrections if the equipment or illumination levels don't match what was approved.
Can a business get its certificate of occupancy held up over lighting?
Yes. Section 4.5 lets the city decline to issue a final Certificate of Occupancy or Certificate of Completion until noncompliant lighting is brought into conformance with the approved plans, to Planning & Zoning staff's satisfaction.

Sources & Official References

Other rules in Goodyear

All Goodyear rules

Compare Goodyear to another location·View the Arizona outdoor lighting overview

Get notified when Light Trespass & Shielding in Goodyear, AZ changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.

Light Trespass & Shielding in Nearby Cities

How other cities in Maricopa County handle light trespass & shielding.

Phoenix, AZ
Some Restrictions
Gilbert, AZ
Some Restrictions
Glendale, AZ
Some Restrictions
Mesa, AZ
Some Restrictions
Surprise, AZ
Some Restrictions
Chandler, AZ
Some Restrictions
Tempe, AZ
Some Restrictions
Peoria, AZ
Some Restrictions