Skip to main content
CityRuleLookup

Port Orange, FL Sign Regulations: Window Signs (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified September 2026

Key Facts

Residential cap
Flat 6 sq. ft. per lot
Multi-family/institutional cap
10% of door and window area
Comm/MXU/Ridgewood cap
50% of door and window area
Permit required
No, in any of the 5 districts
Counts against wall sign area
No, calculated separately
Code section
Ch. 15, § 11(13)

Summary

Port Orange caps how much of a storefront window can carry signage: residential-zoned lots are limited to 6 square feet of window signs, while commercial, mixed-use and Ridgewood Corridor tenants can cover up to half of their total door and window area, all without needing a sign permit.

(13)Window signs. Window signs are subject to the following standards: ... (a)A window sign may be painted on, attached to, or placed within three feet of the inside of a window.(b)The minimum dimensional requirements and number of signs allowed for each district shall be as follows: Standard Res MF/I Comm MXU RC ... Max. sign area 6 sq. ft. 10% of total door and window area for a tenant 50% of total door and window area for a tenant 50% of total door and window area for a tenant 50% of total door and window area for a tenant

View official code

Official source re-checked September 7, 2026: no newer edition of the code had been published (publisher’s edition: Code of Ordinances: Supplement 43 | Land Development Code: Supplement 38).

Full Breakdown

Port Orange's window-sign rule sits in Chapter 15, Section 11(13), 'Permanent signs,' and applies across the five sign districts the chapter establishes in Section 10: Residential (Res), Multi-family/Institutional (MF/I), Commercial (Comm), Mixed-Use (MXU) and the Ridgewood Corridor (RC). A window sign may be painted directly on the glass, attached to it, or placed within three feet of the inside of the window and still be visible from outside, and none of the five districts requires a sign permit for it.

The coverage cap is where the districts diverge sharply. A residential-zoned lot is capped at a flat 6 square feet of window signage regardless of how much glass the building has. Multi-family and institutional buildings get 10 percent of the tenant's total door and window area. Commercial, Mixed-Use and Ridgewood Corridor tenants get the most room: up to 50 percent of their total door and window area for signage. Illumination tightens the same way, from none allowed in Res, to internal lighting only in MF/I, to internal or neon lighting in Comm, MXU and RC. Because window signs run on their own allotment, they do not count against the separate maximum wall sign area a tenant is allowed elsewhere in the chapter, so a business can max out its wall signage and its window signage independently.

Violations & Fines

Window signage that exceeds the district's percentage cap, whether painted directly on the glass, applied as film, or run as a lit display, is treated as an unpermitted sign under the chapter's general enforcement provisions, and the administrative official can require the excess coverage removed or reduced before any related building or sign permit for the tenant space is finalized.

Frequently Asked Questions

How much of my storefront window can I cover with signs in Port Orange?
It depends on zoning. A commercial, mixed-use or Ridgewood Corridor business can cover up to 50 percent of its total door and window area, a multi-family or institutional building is capped at 10 percent, and a residential-zoned property is limited to a flat 6 square feet.
Do window signs need a permit in Port Orange?
No. Section 11(13) of the sign code does not require a permit for window signs in any of the city's five sign districts, whether the sign is painted on the glass, applied as a decal, or hung within three feet of the inside of the window.
Do window signs count against my building's wall sign allowance?
No. The Land Development Code lists window signs as not subject to the maximum wall sign area allowance, so a tenant's window signage is calculated separately from, and does not shrink, the square footage available for wall-mounted signs.

Sources & Official References

Other rules in Port Orange

All Port Orange rules

Florida rules heatmap·Compare Port Orange to another location·View the Florida sign regulations overview

Get notified when Window Signs in Port Orange, FL changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.

Window Signs in Nearby Cities

How other cities in Volusia County handle window signs.

Daytona Beach, FL
Light Restrictions
Deltona, FL
Some Restrictions