Skip to main content
CityRuleLookup

Cheektowaga, NY Building Safety: Electrical Permits (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified September 2026

Key Facts

Permit required before inspection
since 2024 amendment, § 70-24B(4)
Inspector certification
IAEI or ICC plus Code Enforcement Officer
Inspection service liability minimum
$2,000,000 general liability
Annual admin fee
$250, due January 15

Summary

Cheektowaga requires every electrical installation, alteration or repair of wiring for light, heat or power to conform to the Building Code of New York State and be inspected, and since 2024 no inspection can happen without a Town-issued permit number pulled beforehand.

All electrical installations, alterations and repair of wiring for electric light, heat and power shall be made in conformity with the Building Code of New York State, except where the provisions of this chapter or any other local law, ordinance or code of the Town of Cheektowaga shall differently prescribe. ... All applicable permits are required to be pulled prior to work inspection. A permit number is required to be issued by the Town of Cheektowaga prior to any inspection being performed. If one is not provided, the Inspector must refer the party to the Town of Cheektowaga Building Department to obtain the necessary permits. No inspections should be performed without a valid permit. Any inspections performed without a Town-issued permit number will be considered invalid.

View official code

Official source re-checked September 7, 2026: no newer edition of the code had been published (publisher’s edition: rev 4996449; v35 updated 2026-05-26; through 05-26-2026).

Full Breakdown

Cheektowaga Code § 70-24A requires that 'all electrical installations, alterations and repair of wiring for electric light, heat and power shall be made in conformity with the Building Code of New York State,' except where the Town's own chapter or another local law sets a different standard; § 70-2 separately recognizes that Building Code, along with the Fuel Gas and Mechanical Codes, as the Town's official construction standard. Inspections may only be performed by inspectors certified for residential, commercial and industrial work by the International Association of Electrical Inspectors or the International Code Council who are also certified Code Enforcement Officers, and those inspectors must be designated by the Town Board under § 70-24B(2).

As of the 2024 amendment, § 70-24B(4) requires a permit to be pulled before any inspection: 'All applicable permits are required to be pulled prior to work inspection. A permit number is required to be issued by the Town of Cheektowaga prior to any inspection being performed... ' A party seeking Town Board designation as an approved electrical inspection service must carry at least $2,000,000 in general liability coverage, $3,000,000 in professional liability and $1,000,000 in auto liability under § 70-24F(1), name the Town as an additional insured, and pay a nonrefundable $250 annual administration fee due by January 15 under § 70-24F(4).

Violations & Fines

An inspection performed without a valid Town-issued permit number is invalid under § 70-24B(4), meaning the work is treated as uninspected and unapproved. Uninspected or unpermitted electrical work falls under the general Chapter 70 penalty in § 70-9: a fine of up to $250 or 15 days in jail, with each day of continuing violation a separate offense, plus revocation of an electrical inspector's designation for cause under § 70-24E.

Frequently Asked Questions

Can an electrician get an inspection without a Cheektowaga permit?
No. Since the 2024 amendment to § 70-24B(4), a permit number must be issued by the Town before any electrical inspection, and any inspection done without one is considered invalid. If the requesting party has no permit, the inspector must send them to the Building Department first.
Who can inspect electrical work in Cheektowaga?
Only inspectors certified for residential, commercial and industrial work by the International Association of Electrical Inspectors or the International Code Council, who also hold Code Enforcement Officer certification and have been designated by the Town Board under § 70-24B(2). They act as deputized Town agents at no cost to the Town.
What code standard applies to electrical work in Cheektowaga?
Wiring for electric light, heat and power must conform to the Building Code of New York State under § 70-24A, unless a Town local law sets a stricter rule. That Code is one of the eight state codes the Town formally adopted as its construction standard in § 70-2.

Sources & Official References

Other rules in Cheektowaga

All Cheektowaga rules

New York rules heatmap·Compare Cheektowaga to another location·View the New York building safety overview

Get notified when Electrical Permits in Cheektowaga, NY changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.

Electrical Permits in Nearby Cities

How other cities in Erie County handle electrical permits.

Buffalo, NY
Some Restrictions