Wyandotte County, KS Building Safety: Building Inspections (2026)
Key Facts
- Duty holder
- Permit applicant keeps work exposed for inspection
- First stage
- Footing/foundation inspection after excavation
- Final stage
- Final inspection after all permitted work done
- Reinspection fee
- Charged when work isn't ready or uncorrected
- Outside inspectors
- Building official may accept approved agency reports
Summary
Every permitted building project in Wyandotte County must stay open for inspection until each construction stage is approved, and Section 149 places the duty of keeping the work accessible on the permit holder. Section 151 then lists the specific inspection stages, from footing and foundation through the final inspection.
Section 149 Inspections general. Construction or work for which a permit is required shall be subject to inspection by the building official or his designee and such construction or work shall remain accessible and exposed for inspection purposes until approved. Approval because of an inspection shall not be construed to be an approval of a violation of the provisions of this code or of other ordinances of the jurisdiction... It shall be the duty of the permit applicant to cause the work to remain accessible and exposed for inspection purposes.
Full Breakdown
Section 149 (Unified Government Code § 8-25) requires every permitted project to remain open for inspection by the building official until each stage is approved, and it places the duty on the permit holder to keep the work accessible and exposed until inspected. Section 151 then lists the specific inspections the building official must perform, in order: a footing-and-foundation inspection after excavation and any reinforcing steel is placed; an under-floor inspection before subfloor sheathing goes down; an under-slab plumbing inspection before pipes are covered; a sewer-line inspection before the line from the building to the property line is buried; combined rough-in inspections for framing, electrical, plumbing, HVAC, and fireplace work on R-1, R-2, and R-3 occupancies; a lath-or-gypsum-board inspection before plastering or taping; an electrical-service inspection before a new service is energized; a complete-gas inspection once piping and at least one appliance are connected; and a final inspection once all permitted work is done.
Section 152 lets the building official accept reports from qualified outside inspection agencies, and Section 153 requires the permit holder to request each inspection in advance under the inspection-services division's written policies. Section 154 authorizes a reinspection fee whenever work is not ready or a required correction was not made, though not for the first rejection of a job.
Violations & Fines
Covering or concealing work before it passes the required stage inspection, or failing to keep the site accessible for inspection, violates Sections 149 and 155 and is enforced the same as any other chapter 8 violation: a fine of $100.00 to $2,500.00, up to six months in jail, or both, under Section 8-23, plus any reinspection fee assessed under Section 154 for a rejected or missed inspection.
Frequently Asked Questions
Who is responsible for scheduling building inspections?
What inspection stages does Wyandotte County require?
What happens if I cover work before it's inspected?
Sources & Official References
Other rules in Wyandotte County
Compare Wyandotte County to another location·View the Kansas building safety overview
See something wrong?
Help us keep this page accurate. If you notice an error or outdated information, let us know.