Fence Regulations in Bolingbrook, IL (2026)
4 verified fence regulations for Bolingbrook, Illinois, sourced directly from the municipal code and official government pages.
Verified from official government sources
Height Limits
Bolingbrook caps residential fences at six feet generally, but front-yard fences must be decorative and no taller than three feet. Corner-side fences over three feet need a ten-foot setback, and no fence may block the 15-foot corner vision triangle.
Bolingbrook Residential Fence Height Limits
Some RestrictionsBolingbrook Code of Ordinances §§ 54-260(1), (3), 54-255
All fencing in residential districts shall comply with the following requirements: (1)Generally. All fencing shall not exceed six feet in height, unless otherwise specified. ... (3)Corner side yard. All fences located within a corner side yard shall be setback a minimum of ten feet from the property line, unless the fence is three feet or less in height, then the fence shall be allowed to maint...
Fence Permit Requirements
No fence or wall may be built, erected, or replaced anywhere in Bolingbrook without a building permit first. If an HOA covenant covers the lot, the permit application must include a letter from the association confirming the fence was approved.
Bolingbrook Fence Permit Requirement
Some RestrictionsBolingbrook Code of Ordinances § 54-252
It is unlawful to construct, erect or replace on private property in the village any fence or wall, as defined in this chapter, without first obtaining a building permit. Where a fence is to be built on a lot which is subject to a declaration of covenants, conditions and restrictions, no permit shall be issued for such fence unless the permit application is accompanied by a letter from the asso...
Retaining Walls
Any Bolingbrook retaining wall over four feet must be designed by a structural engineer licensed in Illinois, and any wall between two and four feet needs a permit from the village engineer built to village standard or an approved manufacturer's specification. The rule is in Chapter 30's subdivision design standards, Section 30-179.
Bolingbrook Retaining Wall Height and Permit Rules
Some RestrictionsBolingbrook Code of Ordinances § 30-179(a)-(b)
(a)Any retaining wall built, which is greater than four feet in height, shall be designed by a structural engineer licensed by the state.(b)Any retaining wall built, which is greater than two feet in height, but less than or equal to four feet in height shall require a permit from the village engineer. The wall must be constructed per the village standard or approved manufacturer's specifications.
Material Restrictions
Bolingbrook bans fences built with electrically charged wire, barbed wire, spikes, glass, or sharp material designed to injure, plus barbed chain link and most snow fencing. The village board can grant a narrow, conditioned exemption for electric fencing at a sales or storage facility.
Bolingbrook Bans Barbed Wire, Electric Fences
Significant RestrictionsBolingbrook Code of Ordinances § 54-258(b), (c), (d)
All fences or walls constructed in whole or in part of electrically charged current or wire, barbed wire, spikes, glass, protruding nails, or other sharp or pointed material of any kind, or designed to cause injury. Any land owned by the village is exempt from the provisions of this section insofar as it prohibits barbed wire fences. ... (c)All chain link fences with barbed ends up or any chain...
Looking for Will County county-wide rules?
County ordinances apply to unincorporated areas and may supplement Bolingbrook city rules.
Fence Regulations in Will County →