Building Setbacks & Zoning in Shreveport, LA (2026)
3 verified building setbacks & zoning rules for Shreveport, Louisiana, sourced directly from the municipal code and official government pages.
Verified from official government sources
Setback Rules
Required front, interior side, corner side and rear setbacks in Shreveport come from Unified Development Code Table 4-1 and change district by district. Article 7 then lists which accessory structures and architectural features may encroach into those required setbacks.
Setbacks Set by Zoning District in UDC Table 4-1
Some RestrictionsShreveport Unified Development Code § 7.4.C (Supp. No. 19)
Unless otherwise indicated, all accessory structures and architectural features must be at least three feet from any lot line, unless otherwise permitted or restricted by this section or Section 7.3.
Structure Height Limits
Every Shreveport residential zoning district caps building height at 35 feet, measured from grade to the highest point of the roof. Commercial and industrial districts run higher, and downtown sub-districts follow a separate figure rather than a single number.
35-Foot Residential Height Cap, With a Trade-Off Rule
Some RestrictionsShreveport Unified Development Code § 2.4.D.4 (Supp. No. 19)
In any zoning district, except in the downtown sub-districts, any main structure may be erected or altered to a height in excess of that specified for the district in which the structure is located provided that each required front, side, and rear yard is increased one foot for each foot of such excess height
Lot Coverage Limits
Shreveport's Unified Development Code sets two separate caps on every lot: maximum building coverage and maximum impervious surface. Table 4-1 fixes both by zoning district, so a large-lot R-A parcel is held far tighter than a small R-1-5 lot.
Building and Impervious Coverage Caps by Zoning District
Some RestrictionsShreveport Unified Development Code § 2.4.H.2.a (Supp. No. 19)
Pervious concrete and open grid paving systems are calculated as 50% impervious surface, provided that no barrier to infiltration is installed beneath the material. Open grid pavers must be installed on a sand base, without an impervious liner, to qualify.