Building Setbacks & Zoning in Taylor, TX (2026)
3 verified building setbacks & zoning rules for Taylor, Texas, sourced directly from the municipal code and official government pages.
Verified from official government sources
Setback Rules
Taylor's 2024 Land Development Code replaces traditional front-yard setbacks with a 'build-to-line' range that varies by place type. Rural and Large Lot districts (P2, P2C, P2.5) require buildings between 10 and 150 feet from the street, Neighborhood and Manufactured Housing districts (P3, P3M) require 5 to 20 feet, the Mix district (P4) requires 5 to 15 feet, and Urban Center (P5) allows 0 to 15 feet.
Taylor Build-to-Line Setback Standards
Some RestrictionsTaylor Land Development Code § 4.3.1.5; § 7 (Definitions)
4.3.1.5 P3 - NEIGHBORHOOD BLOCKS ... BUILD-TO-LINE (RANGE) 5'-20' ... BUILD-TO-LINE shall mean the line parallel to the street along which the primary mass of the front facade should be set. It is measured as a perpendicular distance from the street line to the nearest point of the building facade.
Structure Height Limits
Taylor's 2024 Land Development Code caps buildings in the P3 Neighborhood place type, the city's standard residential district, at three stories, and Section 5.3.2.1 limits every story citywide to 14 feet from finished floor to finished ceiling. A first-floor commercial space may run from 11 to 25 feet instead.
Taylor Residential Building Height Limit
Some RestrictionsTaylor Land Development Code §§ 4.3.1.5, 5.3.2.1
STORIES (MAXIMUM) 3 STORIES ... Stories may not exceed 14 feet in height from the finished floor to the finished ceiling, except for a first-floor commercial building, which shall be a minimum of 11 feet with a maximum of 25 feet.
Lot Coverage Limits
Taylor's 2024 Land Development Code caps building lot coverage by place type instead of a single citywide number. Nature (P1) lots carry no coverage limit at all, Rural and Large Lot districts (P2, P2C, P2.5) cap at 40%, Neighborhood and Manufactured Housing districts (P3, P3M) at 60%, the Mix district (P4) at 90%, and Urban Center (P5) allows full 100% coverage.
Taylor Max Lot Coverage by Place Type
Some RestrictionsTaylor Land Development Code § 4.3 (Development Standards Table)
LOTS P1 P2 P2C P2.5 P3 P3M P4 P5 CS EC ... LOT COVERAGE (MAXIMUM) N/A 40% 40% 40% 60% 60% 90% 100% TBD TBD
Looking for Williamson County county-wide rules?
County ordinances apply to unincorporated areas and may supplement Taylor city rules.
Building Setbacks & Zoning in Williamson County →