Skip to main content
CityRuleLookup

Titusville, FL Noise Ordinances: Decibel Limits (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified September 2026

Key Facts

Governing section
Titusville Code of Ordinances § 13-102
Residential limit, day
55 dBA, 7 a.m.-10 p.m.
Residential limit, night
50 dBA, 10 p.m.-7 a.m.
Commercial limit
60 dBA at all times
Industrial limit
65 dBA at all times
Measurement threshold
Exceeds limit over 10% of a 10-min period

Summary

Titusville caps sound at the property line under Sec. 13-102: 55 dBA in residential areas from 7 a.m. to 10 p.m. and 50 dBA overnight, 60 dBA in commercial areas around the clock, and 65 dBA in industrial areas at all times, measured for more than ten percent of any ten-minute period.

(d)Maximum permissible sound levels. No person shall operate or cause to be operated any source of sound from any occupancy in such a manner as to create a sound level which exceeds the limits set forth the use district category in Table I, for more than ten (10) percent of any measurement period, which shall not be less than ten (10) minutes when measured at or beyond the property boundary of the land use from which the sound emanates. ... Use District Category Time Sound Level Limit dBA

Residential 7:00 a.m.—10:00 p.m. 10:00 p.m.—7:00 a.m. 55 50 Commercial 7:00 a.m.—10:00 p.m. 10:00 p.m.—7:00 a.m. 60 60 Industrial At all times 65

View official code

Official source re-checked September 7, 2026: no newer edition of the code had been published (publisher’s edition: Code of Ordinances: Supplement 54 Update 1 | Land Development Regulations: Supplement 19 Update 1 | Technical Manuals: Supplement 10 Update 1).

Full Breakdown

Sec. 13-101 makes it unlawful to create any noise exceeding the article's limits except as expressly permitted, and Sec. 13-102 sets the numeric standard in Table I by 'use district category': all residential and general-use zoning districts count as residential, hospital-medical, tourist, business, marina and government uses count as commercial, and all industrial districts count as industrial, with anything unclassified defaulting to the commercial standard. A violation requires the sound to exceed the applicable Table I limit for more than ten percent of a measurement period of at least ten minutes, measured at or beyond the property boundary of the source, and when a residential district abuts a commercial or industrial one, the more restrictive residential limit controls at that boundary.

Where an industrial district adjoins a district that allows residences, the maximum permitted level at the boundary is reduced by six decibels below the table figure. 0002 inch impact at forty cycles per second and above. Short-duration impact sounds like forge hammers, punch presses and metal shears may be measured with an impact noise filter and are allowed six decibels above the standard octave-band sound pressure table. Noises from motor vehicles and other transportation are excluded from the Table I calculation entirely. The article was last substantively amended by Ord. No. 2-2017, § 1, adopted January 10, 2017, following earlier amendments in 2004 and 2009.

Violations & Fines

Exceeding the applicable Table I limit for more than ten percent of any ten-minute measurement period at the property boundary is a violation of Sec. 13-101, punishable under Sec. 13-104: repeat convictions for the same emitter within twelve months can result in the court confiscating the noise-creating equipment, with permanent confiscation on a further violation.

Frequently Asked Questions

How loud can noise legally be in a Titusville residential neighborhood?
Sec. 13-102's Table I sets a residential limit of 55 dBA between 7 a.m. and 10 p.m., dropping to 50 dBA overnight from 10 p.m. to 7 a.m., measured at or beyond the property line of whoever is making the noise.
Where is noise measured from to check compliance?
At or beyond the property boundary of the land use generating the sound, using a sound level meter meeting American National Standards Institute specifications. A violation requires the sound to exceed the district's Table I limit for more than ten percent of a measurement period of at least ten minutes.
What happens near the line between an industrial and a residential district?
The more restrictive residential number governs at that boundary whenever a residential district abuts a commercial or industrial one, and where an industrial district specifically adjoins a residential-permitting district, the maximum level at the line is cut by six decibels below the standard industrial figure in Table I.

Sources & Official References

Other rules in Titusville

All Titusville rules

Florida rules heatmap·Compare Titusville to another location·View the Florida noise ordinances overview

Get notified when Decibel Limits in Titusville, FL changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.

Decibel Limits in Nearby Cities

How other cities in Brevard County handle decibel limits.

Palm Bay, FL
Some Restrictions
Cocoa, FL
Some Restrictions
Melbourne, FL
Some Restrictions