Skip to main content
CityRuleLookup

Monroe Township (Gloucester County), NJ Building Safety: Plumbing Permits (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified October 2026

Key Facts

Standard fixture fee
$15 per fixture, equipment piece or appliance
Special devices
$91 each, including backflow preventers and sewer pumps
Lawn sprinkler
$40
Pool heater with gas piping
$75
Backflow annual reinspection
$75
Minimum permit fee
$75 for a basic construction permit

Summary

Monroe Township, Gloucester County, charges plumbing permit fees under § 104-18 C(1)(b): $15 per fixture, piece of equipment or appliance connected to the plumbing system, $91 per listed special device such as a backflow preventer or sewer pump, and $40 for a lawn sprinkler.

Plumbing fixtures and equipment. The fees shall be as follows: ... The fee shall be $15 per fixture, piece of equipment or appliance connected to the plumbing system, and for each appliance connected to gas piping or an oil piping system except as listed in Subsection C(1)(b)[2] below. ... The fee shall be $91 per special device for the following: grease traps, oil separators, water-cooled air-conditioning units, water connections, sewer connections, refrigeration units, utility service connections, backflow preventers, steam boilers, hot-water boilers (excluding those for domestic water heating), gas piping, gas service entrances, active solar systems, sewer pumps, interceptors and LP gas cylinder, sump pump and pressure booster pump. ... The fee for a lawn sprinkler shall be $40. ... The fee for annual reinspection for all backflow preventer devices that are designed to be field tested and isolate cross-connections between water supply and contaminants shall be $75.

Full Breakdown

Plumbing work in Monroe Township answers to the Plumbing Subcode Official, a member of the Monroe Township Construction Code Enforcing Agency established by § 104-17 A. The fee schedule sits in § 104-18 C(1)(b), 'Plumbing fixtures and equipment,' and the same section sets a $75 minimum for a basic construction permit covering any or all of building, plumbing, electrical or fire protection work.

The standard charge is $15 per fixture, piece of equipment or appliance connected to the plumbing system, and for each appliance connected to gas piping or an oil piping system. Special devices cost $91 each. The printed list is grease traps, oil separators, water-cooled air-conditioning units, water connections, sewer connections, refrigeration units, utility service connections, backflow preventers, steam boilers, hot-water boilers (excluding those for domestic water heating), gas piping, gas service entrances, active solar systems, sewer pumps, interceptors and LP gas cylinder, sump pump and pressure booster pump. An LP fuel pipe other than heaters and an LPG tank install are also $91.

Other flat fees: $40 for a lawn sprinkler and $75 for a swimming pool heater, including the gas piping. Mechanical inspections performed by a plumbing inspector in R-3, R-4 or R-5 are $75 for the first device and $15 for each additional device.

Backflow preventers carry recurring costs. The annual reinspection of backflow preventer devices designed to be field tested, which isolate cross-connections between water supply and contaminants, is $75. A visual inspection by the Plumbing Subcode Official to confirm a device is on site before annual certification is also $75.

Permit timing follows § 104-21: the agency must grant or deny a permit application within 20 business days, and a permit expires if no work starts within one year or work stops for six months. Section 104-17 E requires 24 hours' notice before work begins.

Violations & Fines

Under § 104-25, work contrary to a permit condition, violation of the Uniform Construction Code article, or failure to follow an Enforcing Agency order is punishable by a fine of not more than $1,000, up to 90 days in jail, or both. A knowing refusal of entry to an inspector carries the same ceiling. Stop-construction orders count a separate offense for each day of noncompliance.

Frequently Asked Questions

What is the basic plumbing permit charge in Monroe Township?
Section 104-18 C(1)(b)[1] sets $15 per fixture, piece of equipment or appliance connected to the plumbing system, and for each appliance connected to gas piping or an oil piping system. The overall minimum for a basic construction permit covering building, plumbing, electrical or fire protection work is $75.
Which devices are charged the $91 special device fee?
The $91 fee applies to grease traps, oil separators, water-cooled air-conditioning units, water connections, sewer connections, refrigeration units, utility service connections, backflow preventers, steam boilers, hot-water boilers other than domestic water heating, gas piping, gas service entrances, active solar systems, sewer pumps, interceptors and LP gas cylinder, sump pump and pressure booster pump.
Do backflow preventers need yearly attention?
The fee schedule assumes it. The annual reinspection of field-testable backflow preventer devices costs $75, and a visual inspection by the Plumbing Subcode Official to determine whether a device is located on site, before annual certification, is also $75. Both are listed in § 104-18 C(1)(b).
What does a gas pool heater cost to permit?
The plumbing fee for a swimming pool heater, including the gas piping, is $75 under § 104-18 C(1)(b)[5]. Building permit fees for the pool itself are separate: $150 or $210 for in-ground pools and $100 or $140 for above-ground pools, depending on whether the pool is over 550 square feet.

Sources & Official References

Other rules in Monroe Township (Gloucester County)

All Monroe Township (Gloucester County) rules

Compare Monroe Township (Gloucester County) to another location·View the New Jersey building safety overview

Get notified when Plumbing Permits in Monroe Township (Gloucester County), NJ changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.