Fence Regulations in Burleson, TX (2026)
4 verified fence regulations for Burleson, Texas, sourced directly from the municipal code and official government pages.
Verified from official government sources
Height Limits
In the City of Burleson, Texas, a residential privacy or security fence cannot exceed eight feet in height under Code of Ordinances § 36-11(a). A decorative fence is capped at four feet, and anything inside a visibility triangle, the street-corner area where no structure or growth can pass two feet, is held to a maximum height of two feet.
Fence Height Limits in Burleson, Texas
Some RestrictionsBurleson Code of Ordinances § 36-11
§ 36-11. Residential uses. ... In residentially zoned districts, fences, walls and outdoor area enclosure structures may be erected if in accordance with the following regulations: (a) Privacy/security enclosures. (1) May be fences or walls. (2) Shall not exceed eight feet in height. ... (b) Decorative fence. (1) Shall not be walls; (2) Shall not exceed four feet in height; ... (6) May be allow...
Fence Permit Requirements
In the City of Burleson, Texas, Appendix A § 2.2(3) states that a permit for a fence can be issued on an unplatted lot. Chapter 36 separately bars erecting or altering any fence, wall or outdoor area enclosure that does not conform to it, and caps residential privacy and security enclosures at eight feet.
Burleson Fence Permit and Chapter 36 Conformance
Some RestrictionsBurleson Code of Ordinances, Appendix A, § 2.2(3)
No building permit shall be approved or certificate of occupancy issued on any lot, tract or parcel of land unless and until a plat has been approved in accordance with this appendix, except as provided as follows: ... (3) Platting exemption for certain conditions.A permit for an accessory structure, fence, irrigation system, or swimming pool, may be issued on an unplatted lot.
Retaining Walls
In the City of Burleson, Texas, the Section 105.2 amendment in § 10-142 lists retaining walls not over 4 feet in height, measured from the bottom of the footing to the top of the wall, unless supporting a surcharge or impounding Class I, II, or IIIA liquids. Stormwater rules in § 82-169 give retaining walls no exemption.
Burleson Retaining Wall Four-Foot Line and Stormwater Rule
Some RestrictionsBurleson Code of Ordinances §§ 10-142, 82-169(f)(6)
Section 105.2; under sub-title entitled "Building" amend, delete and re-number as follows: ... 4. 3. Retaining walls that are not over 4 feet in height measured from the bottom of the footing to the top of the wall, at the highest point of the wall, unless supporting a surcharge or impounding Class I, II, or IIIA liquids. ... (f) Non-applicability of section provisions.The requirements of this ...
Material Restrictions
In the City of Burleson, Texas, Code of Ordinances § 36-13 prohibits barbed wire enclosures and electrical fencing citywide, with narrow exceptions for agricultural, rural, commercial, industrial and animal husbandry property. Residential decorative fences also cannot be built of chain link, barbed wire or similar materials under § 36-11(b)(10).
Prohibited Fence Materials in Burleson, Texas
Significant RestrictionsBurleson Code of Ordinances § 36-13
§ 36-13. Miscellaneous uses. ... (b) Barbed wire.Except as provided below, barbed wire enclosure is prohibited within the city: (1) Authorized in the "A" agricultural zoning district and "SFR" single-family rural district, if the fence exists on the property at the time of annexation. (2) Authorized when attached to the top of a security fence of at least six feet in height in the "C" commercia...