Skip to main content
CityRuleLookup

Kyle, TX Noise Ordinances: Decibel Limits (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified September 2026

Key Facts

Lowest-frequency limit
82 dB, 37-75 CPS octave band
Highest-frequency limit
48 dB, 4,800-9,600 CPS octave band
A-scale ceiling
62 decibels for general monitoring
Nighttime adjustment
Subtract 7 decibels after sunset
Measurement point
Bounding property line of the W district

Summary

In the City of Kyle's Warehouse (W) zoning district, City Code Section 53-530 caps noise at the property line by octave band, from 82 decibels in the lowest band (37 to 75 cycles per second) down to 48 decibels above 4,800 cycles, plus a 62-decibel A-scale ceiling, and requires a seven-decibel reduction at night.

§ 53-530. Performance standards for the W district. All uses in the W warehouse district shall conform in operation, location and construction to the minimum performance standards specified as follows for noise ... and vibration: (1) Decibel limits. At no point at the boundary property line of any use in a W district may the sound pressure level of any operation or plant exceed the decibel limits specified in the octave band groups designated in the table in this subsection. a. Maximum permissible daytime octave band/decibel limits at the bounding property line in a warehouse district are as follows: ... Octave band (CPS) Decibel band limit (dB Re 0.0002 microbar) 37—75 82 75—150 76 150—300 68 300—600 60 600—1200 56 1200—2400 53 2400—4800 50 4800—9600 48 A-Scale 62 ... ... b. The following corrections will be made to the table of octave band/decibel limits in determining compliance with the noise level standards in a commercial/manufacturing district: 1. When noise is present at night, any time other than daytime, subtract seven decibels.

Full Breakdown

Section 53-530 sets the performance standards that every use in Kyle's Warehouse (W) zoning district must meet for noise, along with odor, smoke, glare and vibration. The noise rule works off a sound-pressure table measured at the district's bounding property line rather than a single flat decibel number: 82 decibels in the 37-to-75 cycle-per-second octave band, 76 decibels from 75 to 150, 68 decibels from 150 to 300, 60 decibels from 300 to 600, 56 decibels from 600 to 1,200, 53 decibels from 1,200 to 2,400, 50 decibels from 2,400 to 4,800, 48 decibels from 4,800 to 9,600, and a 62-decibel ceiling on the A-weighted scale used for general monitoring.

The code defines daytime as the hours between sunrise and sunset, and the building official treats the bounding property line as the nearest street, alley or open-space right-of-way, or, absent any such buffer, the common line between the two parcels. Section 53-530(b) then layers on corrections: when noise occurs at night, seven decibels are subtracted from the measured level before comparing it to the daytime table, tightening the effective limit after dark. Measurements are taken with a sound level meter or octave band analyzer meeting American Standards Association specifications, so an operator's own noise defense has to be backed by comparable equipment.

Because these are Chapter 53 zoning performance standards, Kyle's general Chapter 1 penalty provision applies to a W-district use that exceeds the table: repeated exceedances give code enforcement grounds to require corrective action or refer the matter for prosecution as a zoning violation.

Violations & Fines

Operating machinery, equipment or a plant in Kyle's Warehouse district that exceeds the octave-band decibel limits in Section 53-530, measured at the bounding property line, is a violation of the district's performance standards. The city building official enforces the table using a certified sound level meter, and a use that will not conform can be cited as a zoning violation and referred for the standard penalties under the city's general enforcement provisions.

Frequently Asked Questions

How loud can a warehouse-district business be in Kyle at the property line?
Section 53-530 sets a decibel table by octave band rather than one number, measured at the boundary line of any Warehouse (W) district use. The limit runs from 82 decibels in the lowest 37-to-75 cycle band down to 48 decibels above 4,800 cycles, with a separate 62-decibel ceiling on the A-weighted scale used for routine monitoring.
Are Kyle's warehouse noise limits stricter at night?
Yes. Section 53-530(b) requires a seven-decibel reduction whenever noise occurs at night rather than during the sunrise-to-sunset daytime period the code defines, tightening the effective ceiling in every octave band after dark for Warehouse (W) district operations measured at the property line.
How does the City of Kyle measure warehouse noise?
Code Section 53-530 requires measurement with a sound level meter or octave band analyzer that meets American Standards Association specifications, taken at the district's bounding property line, defined as the nearest street, alley or dedicated open space, or, if none exists, the common line between the two adjoining parcels.

Sources & Official References

Other rules in Kyle

All Kyle rules

Texas rules heatmap·Compare Kyle to another location·View the Texas noise ordinances overview

Get notified when Decibel Limits in Kyle, TX changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.