Building Setbacks & Zoning in Brick, NJ (2026)
3 verified building setbacks & zoning rules for Brick, New Jersey, sourced directly from the municipal code and official government pages.
Verified from official government sources
Setback Rules
Brick Township sets minimum front, side, and rear yard setbacks separately for each zoning district in Chapter 245's Schedule of Area, Yard and Building Requirements, with special waterfront and deck exceptions written into § 245-10.
Brick Township Yard Setback Rules
Some RestrictionsBrick Township Code § 245-10(B)
Notwithstanding any other provisions of the chapter, the minimum rear yard setback requirements set forth on said schedule for any principle structure shall be the applicable setback requirements for accessory uses from any property line abutting any body of water with the exception of in-ground swimming pools. In-ground swimming pools shall be subject to the setback requirements set forth in §...
Structure Height Limits
Brick Township defines building height by a 35-foot mean-roof-height cap above grade (or elevation 41 feet NAVD 1988), plus a 26-foot eaves-height limit, the objective ceiling zoning officials use to measure every residential structure townshipwide.
Brick Township residential height limit
Some RestrictionsBrick Township Code § 245-3 (definitions, "Building Mean Height")
BUILDING MEAN HEIGHT: The vertical distance from the base reference point to the highest point of the roof for flat roofs, to the deckline for mansard roofs, and to the mean height between eaves and ridge for gable, hip and gambrel roofs, which in no event shall exceed: A. 35 feet above the established average adjacent grade plane; or B. Elevation 41 feet in the N.A.V.D. 1988.
Lot Coverage Limits
Brick Township caps impervious lot coverage, buildings, pavement, walks, and drives, at a maximum percentage set per zoning district in the Code's Schedule of Area, Yard and Building Requirements, enforced through the zoning permit process.
Brick Township Impervious Lot Coverage Limits
Some RestrictionsBrick Township Code § 245-35
A. Maximum impervious area definition shall be the maximum area allowed to be covered on site by impervious surfaces, i.e., buildings, pavement, concrete walks and drives including decks. B. The maximum allowable impervious lot coverage shall be specified in the Schedule of Area, Yard and Building Requirements, referred to in § 245-10 of this chapter.[1] [1] Editor's Note: The Schedule o...