Building Setbacks & Zoning in South Fulton, GA (2026)
3 verified building setbacks & zoning rules for South Fulton, Georgia, sourced directly from the municipal code and official government pages.
Verified from official government sources
Setback Rules
South Fulton sets minimum yard setbacks by zoning district in Table 4-1 under Zoning Ordinance Section 403.03(a). The largest residential lots (R-1, two-acre minimum) carry a 60-foot front, 50-foot rear and 25-foot interior side setback, while the smallest single-family district (R-4, 9,000 sq. ft.) drops to 35 feet front, 25 feet rear and just 7 feet to the interior side lot line.
South Fulton Yard Setbacks by Zoning District
Some RestrictionsSouth Fulton, GA Zoning Ordinance § 403.03(a) and Table 4-1
(a)See Table 4-1 for minimum setback requirements for principal buildings by zoning district. Table 4-1 Area Regulations for Lots and Principal Buildings: Zoning District R-1, Lot Area 2 acres, Front 60', Side 25' to interior lot line 40' to street, Rear 50', Height 40'. Zoning District R-4, Lot Area 9,000 sq.ft., Front 35', Side 7' to interior lot line 20' to street, Rear 25', Height 40'.
Structure Height Limits
South Fulton caps residential building height at 35 feet across every R-1 through R-6 single-family zoning district under Table 4-1, referenced by Zoning Ordinance Section 403.04(a). Exempt features like chimneys, spires, water tanks and flag poles can exceed that limit, and places of worship and private schools get separate allowances up to 75 and 60 feet.
South Fulton Residential Building Height Limits
Some RestrictionsSouth Fulton, GA Zoning Ordinance § 403.04
(a)See Table 4-1 for maximum building height by zoning district.(b)The zoning districts' maximum height limitations for structures shall not apply to the following:(1)Spires, belfries, cupolas and domes.(2)Water storage tanks.(3)Cooling towers.(4)Chimneys.(5)Mechanical penthouses located on roofs.(6)Smokestacks.(7)Flag poles.(8)Silos and grain elevators.(9)Fire towers.(10)Private and special sc...
Lot Coverage Limits
South Fulton's Zoning Ordinance does not set one flat coverage percentage citywide; it assigns a lot-coverage maximum per zoning district in Table 4-1. For the A-1 Apartment Dwelling District, Section 1006.05 caps building coverage, including accessory buildings, at 30 percent of the gross lot area, one of several district-specific limits that run up to 70 percent for office and Apartment-Limited zoning.
South Fulton A-1 District Lot Coverage Cap
Some RestrictionsCity of South Fulton Zoning Ordinance § 1006.05 (A-1 District Lot Coverage)
Sec. 1006.05. - A-1 lot coverage. Maximum coverage of the lot by buildings, including accessory buildings, shall be 30 percent of the gross lot area.
Looking for Fulton County county-wide rules?
County ordinances apply to unincorporated areas and may supplement South Fulton city rules.
Building Setbacks & Zoning in Fulton County →