Queen Creek, AZ Building Safety: Building Inspections (2026)

Every permitted construction project in the Town of Queen Creek moves through a fixed sequence of inspections set out in Town Code Section 7-1-8-3, Required Inspections. The Building Official, upon notification, must make the inspections listed in Sections 7-1-8-3-1 through 7-1-8-3-10: footing and foundation (after excavation and any required reinforcing steel and ufer ground are in place); concrete slab and under-floor (after in-slab or under-floor reinforcing steel, conduit, piping and ancillary equipment are set but before concrete or floor sheathing is installed); lowest floor elevation certificate submissions; frame inspection (after roof decking, framing, fire blocking, bracing, and rough electrical, plumbing and mechanical work are complete, with the weather-resistive barrier applied only after the strap-and-shear inspection passes); lath and gypsum board inspection (before plastering or joint taping, except gypsum board that is not part of a fire-resistance-rated or shear assembly); fire-resistant penetration inspection; energy efficiency inspection covering envelope insulation R and U values, fenestration U value, duct system R value, and HVAC/water-heating efficiency; other inspections the Building Official deems necessary; special inspections documented by a designated special inspection agency before final inspection; and the final inspection once all permitted work is complete.

Section 7-1-8-1 makes it the permit applicant's duty to keep work accessible and exposed until inspected, and bars any inspection from being treated as authorization to violate the Town Building Code. Section 7-1-8-6, Approval Required, prohibits work from proceeding beyond the point covered by each successive inspection without the Building Official's approval; anything that fails must be corrected and cannot be covered or concealed until authorized. A final inspection and approval is required before any occupancy or use begins. Sections 7-1-8-7 and 7-1-8-8 add that gas and electrical suppliers may not turn on service until the Building Official issues a certificate of inspection for that system.