Skip to main content
CityRuleLookup

Bloomfield, NJ Building Safety: Plumbing Permits (2026)

Some Restrictions
Compiled from the official code textEditor Martyn O'NeillLast verified October 2026

Key Facts

Enforcing agency
Community Development Department, with a Plumbing Subcode Official
Per fixture or appliance
$25 per item connected to the plumbing system
Water heater, R-3 and R-5
$90 per unit
Water heater, other use groups
$100 per unit
Backflow preventer, annual testing
$100
Direct fixture replacement
No fee if piping is unchanged

Summary

Plumbing work in Bloomfield Township, New Jersey is priced under § 149-8B(2) of the Township Code: $25 for each fixture or appliance connected to the plumbing system, $90 per unit for water heaters and similar equipment in R-3 and R-5 structures, and $100 per unit in all other use groups. Direct fixture replacement carries no fee.

(2) Plumbing fixtures and equipment: (a) For the purpose of computing fees, the fee for each plumbing fixture or appliance connected to the plumbing system shall be $25 per item, except for the following: [1] For R-3 and R-5 structures, the fee for water heaters, fuel oil piping, steam or hot water boilers, sewer connection, or water service connection, shall be $90 per unit. [2] For all other use groups, the fee for grease traps, water heaters, steam or hot water boilers, sewer pumps, interceptors, furnaces, HVAC units, testable backflow preventers, oil separators, and utility service connections shall be $100 per unit. (b) Generator: $100. (c) Annual testing of backflow preventer: $100. (d) Above-ground oil storage tank: $100. (e) There shall be no fee for direct replacement of fixture(s) where no change is made to the existing piping system, as per N.J.A.C. 5:23-2.7, Ordinary Maintenance.

Full Breakdown

In Bloomfield Township, Essex County, plumbing permits run through the State Uniform Construction Code enforcing agency, the Community Development Department. Section 149-6 lists a Plumbing Subcode Official among the agency's positions, with the Construction Official as chief administrator. The Township Code does not print an adopted plumbing code edition in Chapter 149. It does print the fee schedule in § 149-8B(2), last amended 5-19-2025 by Ord. No. 25-12.

The base charge is $25 per item for each plumbing fixture or appliance connected to the plumbing system. Two groups of equipment are charged differently. In R-3 and R-5 structures, water heaters, fuel oil piping, steam or hot water boilers, sewer connections and water service connections are $90 per unit. In all other use groups, grease traps, water heaters, steam or hot water boilers, sewer pumps, interceptors, furnaces, HVAC units, testable backflow preventers, oil separators and utility service connections are $100 per unit.

Flat charges follow: a generator is $100, annual testing of a backflow preventer is $100, and an above-ground oil storage tank is $100. There is no fee for direct replacement of fixtures where no change is made to the existing piping system, as per N.J.A.C. 5:23-2.7, Ordinary Maintenance.

The general rules of § 149-8 apply on top of the plumbing schedule. The minimum fee for any one subcode is $90, plan review is 20% of the construction permit fee and is not refundable, a change of contractor costs $90 per subcode, and the state training surcharge under N.J.A.C. 5:23-4.19(b) is collected. Mechanical equipment in R-3 and R-5 use groups, such as boilers, furnaces and HVAC units, is separately priced at $90 each under § 149-8B(3).

Violations & Fines

Chapter 149 Article II prints no fine for plumbing work done without a permit. The Plumbing Subcode Official and Construction Official in the Community Development Department administer the schedule, and § 149-8B(4)(l) says violation fees collected remain in the building department at the Construction Official's discretion only.

Frequently Asked Questions

How much is a plumbing permit in Bloomfield Township, NJ?
Section 149-8B(2) charges $25 for each plumbing fixture or appliance connected to the plumbing system. Water heaters, boilers, sewer connections and water service connections in R-3 and R-5 structures are $90 per unit, and the listed equipment in all other use groups is $100 per unit. The $90 minimum per subcode applies.
Is a fee charged to replace a fixture in Bloomfield Township?
No fee applies to direct replacement of fixtures where no change is made to the existing piping system. Section 149-8B(2)(e) ties this to N.J.A.C. 5:23-2.7, Ordinary Maintenance. A change to the piping falls back under the $25 per item charge and the other rates in § 149-8B(2).
What does backflow preventer testing cost in Bloomfield Township?
Section 149-8B(2)(c) sets annual testing of a backflow preventer at $100. A testable backflow preventer installed in a use group other than R-3 and R-5 is also listed at $100 per unit in § 149-8B(2)(a)[2], alongside grease traps, interceptors and oil separators.
Does Bloomfield Township name a plumbing code in Chapter 149?
Chapter 149 does not name an edition. Section 149-6 establishes the State Uniform Construction Code enforcing agency with a Plumbing Subcode Official under N.J.S.A. 52:27D-119 et seq. and N.J.A.C. 5:23. The Community Development Department, the one office location for the public, can confirm the standards applied.

Sources & Official References

Other rules in Bloomfield

All Bloomfield rules

Compare Bloomfield to another location·View the New Jersey building safety overview

Get notified when Plumbing Permits in Bloomfield, NJ changes

We'll email you the moment we detect a change in the code. No spam, unsubscribe anytime.

We'll never sell or share your email. One-click unsubscribe in every email.

See something wrong?

Help us keep this page accurate. If you notice an error or outdated information, let us know.

Plumbing Permits in Nearby Cities

How other cities in Essex County handle plumbing permits.

Newark, NJ
Some Restrictions